Page 1
•DC520 (d).qx 11/6/96 12:02 Page 1 Reset Sync Rev SECONDARY Transport PLAY Input L Auto Tape Selector Dual Auto Reverse Eject Power Direction Mode Dolby NR Cont Play Printed in Taiwan Part #1111-DC520 DC520 – 8•16•96 ver (D) – (Back Cover)
Page 2
Sync Rev Copy High Speed Copy Rec Mute PRIMARY Transport Input Level REC/PLAY Auto Tape Selector Dual Auto Reverse Record Eject n Mode Dolby NR Input Balance Headphones Cont Play Owner’s Manual DC520 – 8•16•96 ver (D) – (Front Cover)
To assure proper operation, and to Verify Line Voltage Before Use avoid the potential for safety hazards, Your DC520 has been designed for use in place the unit on a firm and level North America with 120 volt AC current.
CONVENTIONS The carton and shipping materials used In order to help you use this manual and to protect your new DC520 during ship- make the proper system connections, cer- ment were specially designed to cushion tain conventions appear throughout the it from shock and vibration.
Harman Kardon remote controls. Keep this area clear if you wish to use the DC520 with a remote control. (not included) D Secondary Counter Reset – Press this button to reset the counter for the secondary transport to “0000”...
6. If you wish to clear the counter before Single Deck Playback playback, press the The DC520 may be used as a convention- to the transport you will be using. al auto reverse audio cassette deck, play- 7. Press the ing back tapes from either transport.
With the switch in this mode, the button for the length of time the DC520 will play or record in whichever blank space is desired. When the button direction is selected and then stop at the is released the unit will automatically go end of one side of the tape.
Page 9
FORWARD REVERSE PLAY buttons to start the playback. DC520 – 8•16•96 ver (D) Operation Once playback is started, the DC520 will 4. Press the first play the entire first side of the trans- buttons port where the button was pressed.
Page 10
Primary Transport (record cassette) will stop while the Secondary Transport (playback cassette) will continue to play. Listen to the output of the DC520 using either the tape monitor mode on your audio system or the front panel head- phone jack .
A wide variety of these products is available from your dealer. Carefully fol- low the instructions in the cleaning kit to avoid damage to your DC520. 2. Remove the cassette from the transport to be cleaned. Slightly dampen a cotton...
Page 12 The DC520 is designed for trouble free operation. However, like any mechanical device it may occasionally malfunction. In most cases the trouble can be resolved simply by finding the problem from the list below and following the steps outlined. If a problem per- sists, contact your dealer or an authorized Harman Kardon Service Center.