Energizer ER-OF800 Specifications

Congratulations on your new Energizer® ER-OF800 UPS Power Protection system.
This product is specifically designed for home office and workstation. With the newest technology, this series
can operate under a wide range of input utility power while maintaining steady output voltage. Why is this
important? Some equipment requires consistent backup power under high utility fluctuation. Because the
number of computer peripherals increase, additional surge protected outlets are provided to protect your
printer, scanner or other peripheral devices from surges, spikes, and electromagnetic interference.
Specifications
Color Black
Run Time 5 to 42 minutes
Surge Protected vs.
4:4
Battery Backup Outlets
Warranty 3 years
Internet Ready/Phone/Fax
RJ11/RJ45
Modem hookups
VA Rating 800
Watts 400
Input/Output Voltage 115
Frequency 60
Interface Port (USB or Serial) RJ48 (USB and Serial)
9
12
SITE WIRE FAULT
10
INTERFACE
IN FAX/MODEM
8
SURGE PROTECTION BACKUP POWER OUTLET
6
CIRCUIT
BREAKER
Your box should include the following:
UPS unit and Input Power Cord
User's Manual
Telephone Line Communication Connection Cord
Remote Monitoring Software
Waveform Type
Joules (surge capacity)
Overload Protection
Recharge Time (typical)
Visual Indicators (lights)
Audible Indicators
Connected Equipment
Unit Dimensions/Weight
2
3
BUCK
4
BOOST
OVERLOAD
5
OUT
7
11
AC INPUT
Stepped Sinewave
748
Yes
<=8hrs of 90%
4
4
3 years
Guarantee
13.4 x 3.4 x 6.1
Compliance CUL
Cord Length 6 feet
1
Item
1
2
Battery Indicator (green)
AC
BATT
3
4
Overload/Abnormal Indicator
5
6
7
8 Surge Protection Outlets
9
10
11
Site Wire Fault Indicator
12
ER-OF800
Features:
Compact light weight design
Intelligent microprocessor control
Unparalleled communication with your computer
Provides accurate information for control and
monitoring power
Overload protection and alarm
Smart AVR for low and high input line voltage
Fax/modem surge suppression port
Site-Wiring-Fault indicator
Easy battery replacement mechanism
Description
Panel Indicator
On/Off Switch Turns UPS system on & off
AC Normal/On Indicate the AC is normal or
that the UPS is in battery mode
Buck Mode Indicator Measures and restores normal
(yellow) AC voltage if it is too high
Boost Mode Indicator Measures and restores normal
(yellow) AC voltage if it is too low
Indicates the UPS output is
overloaded or that there is
(red)
UPS failure
Protect against UPS
Input Circuit Breaker
system overload
Provide output power
Backup Power Outlets
to computer device
Provides a noise filtering function
to computer peripherals
Allows remote monitoring and
RF48 port
control via serial interface ports
Telephone Surge Suppress the spoke voltage
Protection Port on the telephone line
Connects to input utility power
AC Power Input
through the input power cord.
Indicate missing ground
(red) or polarity reversed