Connecting To Ac Power; Using Ac Line Conditioners; Leaving The Ac Power On; Break-In And Warm-Up - Burson HA-160 User Manual

Avoid allowing static shocks to be applied to the inputs or outputs. To prevent static shocks, touch any grounded
surface, such as the chassis of a component that is plugged into an AC socket, before connecting or removing a cable.
Inputs and outputs can be safely connected to the Burson HA160 when the AC power is switched off.

Connecting to AC Power

Check to make sure your Burson HA160 has been manufactured for operation at your AC line voltage. Attempting to use
your Burson HA160 at any voltage other than specified on the rear of the unit may cause damage that is not covered by
Burson's warranty.

Using AC Line Conditioners

Of the wide range of power line conditioners currently available, some can provide substantial improvement in sound
while others actually degrade sonic performance. Use caution in selecting a power line conditioner for your system. In
particular, avoid using inexpensive "surge protectors". Although these can prevent damage from high voltage spikes,
they often degrade performance

Leaving the AC power on

Some said that leaving the power on allows the circuitry to remain at a constant operating temperature, providing
better performance and longer life. However, there is always a slight increase in risk of fire or damage to any
electrical component when the power is left on. We believe that it is not necessary for the HA-160 to be remained on
constantly.

Break-in and warm-up

Careful listeners will notice that the sound of the Burson HA-160 improves steadily after the unit is powered-up. A new
unit will undergo more dramatic changes when power is applied for the first time. Depending on the resolution of the
system and the attentiveness of the listener, you may find that the sound continues to improve over the first several
weeks of operation. If the power is disconnected for a period of an hour or more, the unit will undergo similar but less
dramatic break-in.

Tips

Connect your HA160 directly to the wall socket with a good quality power cable Instead of channel thought a
•
power board will yield better results.
Warm up your HA160 for 30 min is recommenced before each listening section.
•
It is recommended to apply contact clearing product such as Deoxit ProGold Contact Cleaner to all input and
•
output connectors every 6 months.
6