JVC D-ILA DLA-RS67 Instructions Manual page 68

Remote control does not work
Check
Are the batteries correctly loaded?
Are the batteries exhausted?
Is there an obstructing object between
the remote control and remote sensor?
Is the remote control held too far away
from the unit?
Are the IR (infrared) 3D GLASSES and
3D SYNCHRO EMITTER in use?
The lens cover does not close
Check
Is "Lens Cover" set to "Open"?
Noise is heard
Check
Is the exhaust vent blocked?
Is the unit used near a heater or air-
conditioner?
Are you viewing 3D video images?
Is the "Picture Mode" or "Color Profile"
changed?
Did you change the "4K e-shift" setting
for "MPC Level"?
There are small black or colored dots on the screen
The D-ILA device is manufactured using high-precision technologies, but there may be some (less than 0.01%) missing
pixels or pixels that remain permanently lit. This is not a malfunction.
68
Match the polarities (t s) correctly when loading the
batteries.
Replace with new batteries.
Remove any obstructing object.
Hold the remote control closer to the sensor during use.
As there is a possibility of signal interference, when you are
using the IR (infrared) 3D GLASSES together with the 3D
SYNCHRO EMITTER, try adjusting the orientation of the
3D SYNCHRO EMITTER.
Set "Lens Cover" under "Lens Control" in the setting menu
to "Auto".
Check the installation condition of the projector.
When the surrounding temperature of the projector is high,
the fan revolution speed increases to protect the projector
unit, hence a louder operating sound.
"Lamp Power" is set automatically to "High" to ease viewing
of 3D video images, hence a louder fan operating sound.
If you are bothered by the sound, set it to "Low".
Operating sound is generated by the cinema filter. This is
not a malfunction.
Switching sound is generated. This is not a malfunction.
Action
Action
Action
Refer to
p. 18
p. 18
p. 18
p. 18
p. 32
Refer to
p. 52
Refer to
p. 19
p. 47
—
—