Advertisement
Instructions
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
Pressure Roller with
20-inch Fixed Extension
- For application of architectural paints and coatings -
Model 287713, Series A
•
20 inch (50 cm) heavy-duty extension
•
9 inch (23 cm) roller frame
•
1/2 inch (13 mm) nap roller cover
3600 psi (24.8 MPa, 248 bar) Maximum Working
Pressure*
*The best operating pressure is the lowest pressure that
provides an even paint supply to the roller and typically
does not exceed 300 psi (2.1 MPa, 21 bar).
CAUTION
Never leave water in pump, gun or pressure roller.
Doing so could cause corrosion and damage from
freezing. For storage, flush the system with Pump
™
Defender
or mineral spirits/paint thinner.
311082B
Advertisement
Table of Contents
Related Manuals for ASM 287713
Summary of Contents for ASM 287713
- Page 1 Read all warnings and instructions in this manual. Save these instructions. Pressure Roller with 20-inch Fixed Extension - For application of architectural paints and coatings - Model 287713, Series A • 20 inch (50 cm) heavy-duty extension • 9 inch (23 cm) roller frame •...
-
Page 2: Personal Protective Equipment
Warnings The following warnings are for the safe setup, use, grounding, maintenance, and repair of this equipment. The excla- mation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. Refer back to these Warnings. Additional, product-specific warnings may be found throughout the body of this manual where applicable. -
Page 3: Pressure Relief Procedure
Pressure Relief Procedure Follow this Pressure Relief Procedure when you stop spraying and before cleaning, checking, servicing, or transporting equipment. 1. Turn power switch OFF and unplug sprayer power cord. 2. Turn spray/prime valve to PRIME to relieve pressure. 3. Hold metal part of gun firmly to side of a grounded metal pail. - Page 4 Cleaning This is the procedure for flushing/cleaning the pressure roller. The sprayer and gun you are using may have ad- ditional flushing/cleaning instructions; such as cleaning filters and screens. See sprayer and gun operation man- uals. • Leave pressure roller attached to gun for this procedure.
- Page 5 Parts Ref. Part No. Description 15B052 FRAME, roller 245999 CAP, end (includes seal and retainer) 246277 CAP, end (includes seal, retainer, and o-ring) 197106 CLIP, roller 197118 FITTING, swivel 162863 GASKET 114049 O-RING 197117 NUT, retaining 704-25G FITTING, extension, male 15A619 GASKET 7422R...
-
Page 6: Standard Warranty
ASM Standard Warranty Standard Warranty ASM warrants all equipment referenced in this document which is manufactured by ASM and bearing its name to be free from defects in material and workmanship on the date of sale by an authorized ASM distributor to the original purchaser for use. With the exception of any special, extended, or limited warranty published by ASM, ASM will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by ASM to be defective.
Need help?
Do you have a question about the 287713 and is the answer not in the manual?
Questions and answers