Frigidaire ES200 Use & Care Manual page 17

Fig. 2
about
10°
oven
door
hinge
Fig. 3
roller
pin
hinge
arm
General Care & Cleaning
Oven door
hinge
locations
Fig. 1
Fig. 4
Removing and Replacing the Lift-Off Oven Door
The door is heavy. For safe, temporary storage, lay
the door flat with the inside of the door facing down.
To Remove Oven Door:
1. Open oven door completely (horizontal with floor - See Fig. 1).
2. Pull the door hinge locks on both left and right door hinges
down from the oven frame completely towards the oven door
(See Fig. 2). A tool such as a small flat-blade screwdriver may
be required.
3. Firmly grasp both sides of oven door along the door sides (Do
not use the oven door handle - See Fig. 3).
4. Close the door to the broil stop position (the oven door will stop
into this position just before fully closing).
5. With the oven door in the broil stop position, lift the oven door
hinge arms over the roller pins located on each side of the oven
frame (See Fig. 4).
To Replace Oven Door:
1. Firmly grasp both sides of oven door along the door sides (Do
not use the oven door handle - See Fig. 3).
2. Holding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller pins
located on each side of the oven door frame (See Fig. 4). The
hook of the hinge arms must be fully seated onto the roller pins.
3. Fully open the oven door (horizontal with floor - See Fig. 1).
4. Push the door hinge locks up towards and into the oven frame
on both left and right oven door hinges (See Fig. 2) to the locked
position.
5. Close the oven door.
Special Door Care Instructions - Most oven doors contain
glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are fully in
place.
2. Do not hit the glass with pots, pans, or any other object.
3. Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
time.
17