Features - Ryobi RP4530 Operator's Manual

KNOW YOUR SMART HEADPHONES
See Figure 1, page 10.
The safe use of this product requires an understanding of
the information on the product and in this operator's man-
ual. Before use of this product, familiarize yourself with all
operating features and safety rules.
NOTE: The earphone with the battery compartment will be
referred to as the LEFT side. The earphone with the volume
control will be referred to as the RIGHT side.
ADJUSTABLE PADDED HEADBAND
The adjustable headband is flexible and padded for operator
comfort.
AUTO POWER-OFF
Your headphones will automatically shut down if they are
not in use for four hours.
1/8 IN. AUXILIARY INPUT JACK AND CABLE
Allows you to listen to MP3 and similar sound devices.
PRODUCT SPECIFICATIONS
Voltage .......................................................................4V DC
*IP Rating: Specifies the environmental protection the product enclosure provides. An IP Rating of 54 denotes protection against harmful
deposits of dust and protection against water sprayed from all directions. The water resistance rating applies only when the battery cap
is installed.
ATTENUATION DATA
Freq. Hz
125
Mean
16.0
Std. Dev.
3.5
The NRR calculated from these laboratory-based attenu-
ation data is 25. Improper fit of this device will reduce its
effectiveness in attenuating noise. Consult instructions for
use for proper fit.
The level of noise entering a person's ears when a hearing
protector is worn as directed is closely approximated by
the difference between the A-weighted environmental noise
level and the NRR.
EXAMPLE:
1. The environmental noise level as measured at the ear is
92 dBA.
2. The NRR is 25 decibels. (dB)
3. The level of noise entering the ear is approximately
equal to 67 dBA.
CAUTION: For noise environments dominated by frequen-
cies below 500 Hz, the C-weighted environmental noise
level should be used.
Earmuffs must be worn at all times in noisy surroundings
for proper protection.
250 500 1000
21.4 25.7 35.7
3.5 2.4 3.7

FEATURES

LOW POWER CONSUMPTION
Your headphones feature low energy requirements during
normal use for extended operation.
MICROPHONES
The microphones allow you to hear your voice as well as
background noise. They are controlled with the volume knob
on the right earphone.
NOISE SUPPRESSION
Electronic noise suppression allows for normal human con-
versation while limiting the environment noise.
QUICK RESPONSE CIRCUITRY
Helps reduce impulse noise such as gun shots and ham-
mer blows.
ON/OFF/VOLUME KNOB
The on/off/volume knob, located on the right earphone, con-
trols the microphone level and ambient noise being transmit-
ted through the earcups. It also turns the power on and off.
IP Rating ........................................................................54*
2000 3150 4000
32.0 39.9 40.7
3.0 3.0
Although hearing protec-
tors can be recommended
for protection against the
harmful effects of impul-
sive noise, the noise reduc-
tion rating (NRR) is based
on the attenuation of con-
tinuous noise and may not
be an accurate indicator of
the protection attainable
against impulsive noise such as gunfire. (Wording required
by EPA)
The EPA has selected the NRR as the measure of a hearing
protector's noise reducing capabilities. Aearo Technologies
makes no warranties as to the suitability of the NRR as a
measure of actual workplace protection since such protec-
tion is highly dependent on user training, motivation, and
utilization. A better estimate of workplace protection can be
obtained by derating the labeled NRR of this, or any other
hearing protector, by 50%.
6
6300 8000
36.0 34.0
3.3 4.4 6.1
ANSI S3.19-1974
NRR CSA Class
25 A