Table of Contents
Advertisement
Multimedia
GPS Navigation Interface
Precautions and Safety Warning
1. Use GPS carefully. This system just provides navigation reference for you. Never use this system
for precise measurement of position, distance, location, terrain and others.
2. When you use GPS for the first time, park your car at one open space without a shelter. Positioning
requires at least two minutes based on the environment and strength of satellite signals.
3. For your safety, set up the route before you set off. Never operate this system while you are driving.
We are not liable for any traffic accident that occurs when you operate this system rather than pay
attention to the road condition while driving.
4. This system cannot provide correct positioning and navigation if satellite signals are interfered by
tunnel, building, subway, forest, weather, tall obstacle or mobile phone base station. The system
resumes normal positioning and navigation after you move away from these sources.
5. Note that satellite signals may be interfered by any wireless communications product (such as a
cell phone or speed alarm) and become unstable.
6. Road planning is for reference only. Road properties, such as one-way road and no left turn, may
be
adjust e d
by the local traffic department based on transportation circumstance, road
construction, governmental or commercial activities. Therefore, you must obey current traffic
rules relating to road conditions and signs. If the current road conditions are different from the
map, choose an appropriate route.
GPS Navigation Functions
This system provides a navigation map (note: this map applies to certain models).
(A) The GPS navigation system provides proportional real-time crossing data to display the
actual crossing, so you do not have to worry about driving at a complex crossing.
Instructions Car
8
Instructions Car
9. System Information:
This page displays product information, Touch Calibration and Reset. Touch Touch Calibration to
display the calibration page.Method 1: Touch Calibrate Coordinate Center to start calibration. If calibration
fails, the system displays the calibration page again. If calibration is complete, the system exits the page.
Method 2: Continuously press [
], [ZOOM], [
Touch this cursor for calibration and then exit the interface. Method 3: Press [
on the panel to enable calibration.
10. System Setting:
Reversing Mirror Image: Touch to display images of the rearview mirror. Touch-tone: Touch to
enable or disable the touch-tone. LED1/LED2: Touch to change LED to blue or orange. Brake Detection:
If you do not touch this button, brake detection is disabled. In this case, you can watch videos while
driving the car, but this is illegal in certain countries. Therefore, for your safety, touch this button to
enable the function.
Multimedia
] and [
] on the remote controller to display a + cursor.
] for about eight seconds
21
Advertisement
Table of Contents
