Bridge - Grizzly H3099 Owner's Manual

Bridge

To fit the bridge:
1.
Place the bridge on the violin top, centered
between the inside notches of the f-holes
(Figure 9). Note—When viewed from the
side, the flat side of the bridge should face
the butt of the violin and the tapered side
should face the front (Figure 10).
G-string
Location
Figure 9. Bridge location.
2. Using a steel ruler, check the height of the
bridge in relation to the top surface of the fin-
gerboard. The E-string location on the bridge
must be 2.5 to 3mm above the fingerboard.
The G-string location on the bridge must be
4.5mm above the fingerboard.
— If both of these conditions are present,
then continue with step 4.
— If either of these conditions are NOT pres-
ent, then continue with the next step.
H3099 Deluxe Violin Kit
E-string
Location
-11-