Table of Contents
Advertisement
Introduction
The SIRIUS Home Satellite Radio Receiver must
be connected to the windowsill antenna (supplied)
to process the SIRIUS signal. The Receiver
recognizes and decodes the incoming SIRIUS
program information and provides an audio signal
to your stereo receiving equipment or other audio
output equipment.
NOTE: The SIRIUS signal can be received and
processed virtually anywhere as long as there are
no obvious obstructions such as nearby buildings,
high terrain, parking garages or tunnels which
would block the satellite antenna from having a
clear view of the sky. The Receiver is typically
installed in an accessible location close to your
stereo receiving equipment to permit integration
as part of your home stereo system.
10
Installing Your SIRIUS Receiver
You can begin to enjoy Sirius Satellite Radio as soon
as the Receiver installation is complete. Set up your
Receiver using the following installation instructions.
Installation/Wiring Precautions
1. Make sure the power supply adapter cable is
not connected to an AC wall outlet until all
interconnections have been made and
verified. The power supply adapter cable
should be connected last.
2. Do not install the Receiver in the locations
exposed to direct sunlight or in areas subject
to extreme temperatures.
3. Incorrect installation may cause damage to
the system.
4. During antenna placement/installation, refer
to the Antenna Placement procedure on page
12.
SRH550C User Guide
Advertisement
Table of Contents
