Summary of Contents for Sirius Satellite Radio SIR-ALP10T
Page 1
SIR-ALP10T ALPINE COMPATIBLE SIRIUS SATELLITE RADIO PLUS TRAFFIC TUNER Installation Guide...
Page 2
Congratulations on your purchase of the SIR-ALP10T, the Alpine Compatible SIRIUS Satellite Radio Plus Traffic Tuner! Your new SIRIUS Radio Plus Traffic Tuner is designed to work with compatible Alpine satellite radio ready headunits and traffic ready navigation systems. Contact Alpine or SIRIUS for model compatibility.
• Relocate the receiving antenna. • Consult the dealer or an experienced technician for help. SIR-ALP10T Installation Guide...
Page 5
If the wiring must pass through a metal hole, be sure to use a rubber grommet to prevent the wire’s insulation from being cut by the metal edge SIR-ALP10T Operation and Installation Guide SIR-ALP10T Installation Guide of the hole. USE THE SPECIFIED ACCESSORY PARTS AND INSTALL THE PRODUCT SECURELY.
• Any location that would interfere with moving parts on the vehicle or interfere with driving. Mounting the SIR-ALP10T Tuner Be sure that you find a location that is flat and has clearance above the tuner to prevent any damage, as well as allow for ventilation.
• From the trunk, carefully route the cable to the location of the SIR-ALP10T and plug the SMB connector into the tuner. SIR-ALP10T Installation Guide SIR-ALP10T Operation and Installation Guide Sedan/Coupe...
DATA Make sure to insert firmly to lock the connector in place. 1 ACC (Ignition Switched) - Used in standalone navigation system applications (no audio headunit) Battery (+) Ground (-) No Connection SIR-ALP10T Installation Guide...
Page 9
Headunit – it can be either Input or Output depending on the position of the Ai-NET switch on the bottom of the unit. SIR-ALP10T Installation Guide SIR-ALP10T Operation and Installation Guide Antenna (21’ cable) Mount on Roof of Vehicle Note: Connect the RED (ACC/IGN) wire ONLY when using the SIR-ALP10T without an Alpine headunit.
System Connection Examples System 1: Alpine Navigation System and SIR-ALP10T Alpine Monitor System (TME-M770 or TME-M710) Note: For this system configuration, be sure to connect the RED wire on the SIR-ALP10T to a fused ACC or IGN line. EX-2 DISPLAY...
Page 11
Ai-NET Switch Set to NORM~ Default Setting. Alpine Navigation System (NVE-N872A) DISPLAY Alpine Monitor System (TME-M770 or TME-M710) Note: For this system configuration, DO NOT connect the RED (ACC/IGN) line on the SIR-ALP10T. SIR-ALP10T Installation Guide SIR-ALP10T Operation and Installation Guide BOTTOM COVER...
Page 12
Alpine CD Changer (CHA-S634) / Alpine iPOD interface (KCA-420i) Alpine Navigation System (NVE-N872A) DISPLAY Alpine Monitor System (TME-M770 or TME-M710) Note: For this system configuration, DO NOT connect the RED (ACC/IGN) line on the SIR-ALP10T. BOTTOM COVER (FRONT VIEW) EX-2...
Page 13
Ai-NET NORM EQ DIV Ai-NET Switch Set to NORM ~ Defaut Setting Note: For this system configuration, DO NOT connect the RED (ACC/IGN) line on the SIR-ALP10T. SIR-ALP10T Installation Guide SIR-ALP10T Operation and Installation Guide Alpine CD Changer (CHA-S634)/Alpine iPOD interface (KCA-420i)
Page 14
CD-Changer or IPOD Interface, Audio Processor, and SIR-ALP10T Alpine Multimedia Station Headunit (IVA-D300, IVA-D310, IVA-D901) Hideway Headunit Tuner Module Alpine Navigation System (NVE-N872A) DISPLAY Note: For this system configuration, DO NOT connect the RED (ACC/IGN) line on the SIR-ALP10T. Special Note Bottom of Tuner Module Ai-NET...
If you do not have access to the SID stickers on the packaging or on the product, you can obtain the Audio SID using the following method. 1. Make sure that the SIR-ALP10T is properly connected, and that the antenna is oriented to receive the SIRIUS satellite signal.
Page 16
SIR- ALP10T is not connected, or connected incorrectly. Check to be sure you have correctly installed the SIR-ALP10T according to the instructions in this manual. 6. The next Setup screen will display the Data SID near the bottom of the screen where it says Sirius ID .
ENTER button. SIR-ALP10T Installation Guide SIR-ALP10T Operation and Installation Guide 6. The next Setup screen will display the system status and the traffic setup parameters. The following sub-sections explain each of the traffic information setup parameters.
Page 18
When you select Detour in the Traffic Incident List screen, or press the Detour button on the remote control, the system will allow you to detour your route based upon the setting you have chosen, traffic or distance. SIR-ALP10T Installation Guide...
Detour Based On , or select it by tilting the joystick to highlight your selection and press the ENTER button. Basic Operation The SIR-ALP10T SIRIUS Satellite Radio Plus Traffic Tuner is compatible with most Alpine satellite ready headunits from 2001 and up. The satellite traffic data is compatible with the NVE-N872A Navigation System.
Page 20
ENTER button, displays a list of the icons associated with each incident, and defines the meaning of each icon. Icon Legend Accident Blockage Construction / Roadworks Danger Debris Disabled Vehicle Information Sports Event Traffic Jam Weather SIR-ALP10T Installation Guide...
UPDATING or CALL 1-888-CALL SIRIUS TO ACTIVATE - This message appears when the SIR-ALP10T is receiving a subscription update or during a channel or category update. NO SIGNAL or NO SIGNAL or ACQUIRING - Will be displayed when there is a weak or no antenna signal present.
Please write down your SIRIUS IDs in the space provided below: SIRIUS Radio Service SID: SIRIUS Traffic Service SID: SIRIUS Customer Service: 1-888-539-7474 105mm x 126mm x 35mm (WxHxD) 127mm x 126mm x 35mm (WxHxD) 3.5 Meter Data Cable (Male/Male) SIR-ALP10T Installation Guide...
12 MONTH LIMITED WARRANTY Sirius Satellite Radio warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company’s...