Table of Contents
Advertisement
Evolut ion Sa fa ri Sc oot e rs
DRIVE/FREEWHEEL OPERATION (FIG 8)
The drive/freewheel lever (yellow ball handle) is located under the seat at the right rear of unit. This
lever allows you to disengage the drive mechanism and push the scooter while in freewheel mode.
To disengage the drive mechanism (neutral), move the lever forward (the scooter can now be
pushed). To re-engage the drive mechanism (drive), move the lever backward (now the unit may be
driven).
Note: The scooter will not operate while the drive/freewheel lever is in the neutral position
(forward). The scooter must be turned off, lever moved backward (drive position) and then turned
on in order to reset the circuits.
WARNING! Always re-engage the free-wheeling device after use. Failure to do so may result in
injury.
Anti-tip wheels
The anti-tip wheels are located at the rear of the scooter frame (Fig 8). The scooter should not be
used unless the anti-tipping wheels are in place.
Evolution Technologies Inc. is not responsible for damage or injury incurred due to improper or
misuse of the scooter.
Scooter serial number
The scooter serial number is located on the seat post and consists of a combination of 13 numbers
and letters. Evolution recommends that you write the serial number down on the back of this
manual for future reference. Refer to Fig 5.
Freewheel
Lever
Anti-tip wheels
Figure 8
10
Frame Detach
Lever
Advertisement
Table of Contents
