Table of Contents
Advertisement
AUDIO CONTROL / MODE
Manual tone adjustment function—
This knob is used to adjust the tone
manually.
For
low- pitch
tone
adjustment,
"AUDIO CONTROL / MODE" repeatedly
until "BAS" appears on the display. Then
turn the knob to suit your preference.
The display will show the range from
"BAS -5" to "BAS 5".
With middle- pitch tone—
For middle- pitch tone adjustment, push
"AUDIO CONTROL / MODE" repeatedly
until "MId" appears on the display. Then
turn the knob to suit your preference.
The display will show the range from "MId
- 5" to "MId 5".
For
high- pitch
tone
adjustment,
"AUDIO CONTROL / MODE" repeatedly
until "TRE" appears on the display. Then
turn the knob to suit your preference.
The display will show the range from
"TRE -5" to "TRE 5".
118
Sound balance adjustment function—
This knob is also used to adjust the
sound balance between the front and rear,
and the right and left speakers.
For front/rear adjustment, push "AUDIO
push
CONTROL / MODE" repeatedly until "FAd"
appears on the display. Then turn the
knob to adjust the front/rear balance.
The display will show the range from "FAd
F7" to "FAd R7".
For
left/right adjustment,
CONTROL / MODE" repeatedly until "BAL"
appears on the display. Then turn the
knob to adjust the left/right balance.
The display will show the range from "BAL
L7" to "BAL R7".
push
'99 AVALON (USA/CANADA)- U
CD (Compact Disc)
Push "CD" to switch from radio operation
to compact disc operation. If the audio
system is off, you can turn on the com-
pact disc player by pushing "CD". In both
cases, a disc must already be loaded in
the player.
When the audio is set into compact disc
operation, the display shows the track or,
track and disc number currently being
played. Each time you push "CD", the
push "AUDIO
system changes between built- in single
disc player and automatic changer.
If the player malfunctions, your audio sys-
tem will display one of the six following
error messages.
If "WAIT" appears on the display, it indi-
cates inside the player unit may be too
hot due to the very high ambient tempera-
ture. Remove the disc or magazine from
the player and allow the player to cool
down.
If "Err 1" appears on the display, it
indicates the disc is dirty, damaged, or it
was inserted up- side down. Clean the
disc or insert it correctly.
Advertisement
Table of Contents
