Toyota Solara 2001 Operating Manual page 151

2. Bring the hand held garage door open-
er to within about 25 mm (1 in.) of the
button being programmed and push the
button on the hand held garage door
opener. The signal from the hand held
garage door opener is sent to the ve-
hicle's opener.
3. When the frequency and code is regis-
tered, the indicator light flashers rapid-
ly. At this point, your can release both
buttons.
4. To program the remaining buttons, re-
peat steps 1 through 3.
NOTICE
Canada only:
As your hand held garage door open-
er may automatically stop sending the
signal during programming, press and
re–press the hand held garage door
opener button every two seconds dur-
ing steps 1 through 4 above until the
frequency and code is registered.
If you want to replace an existing program
with a new program, select the button you
want to program. Follow the procedure
from step 1.
'01 SOLARA_U (L/O 0009)
If the transmitter has a rolling code
feature, it is necessary to program the
in–garage receiver after programming
HomeLink_.
1. Locate the training or learning but-
ton on the in–garage receiver and
push and release this button. Loca-
tion of the button may vary among
garage door opener manufacturers.
2. Firmly push and release the trained
HomeLink_ button 2 times (some ga-
rage door manufacturers may require
you to push the HomeLink_ button
up to 3 times) to complete the pro-
cess.
The garage door should now operate
when the HomeLink_ button is pushed.
Do not use the HomeLink_ universal
transmitter with any garage door opener
that lacks the safety stop and reverse
feature as required by Federal Safety
Standards. This includes any garage door
opener model manufactured before April 1,
1982.
2001 MY SOLARA (OM33527U)
CAUTION
When programming or operating the
garage door opener, make sure there
is no one around the moving door.
(b) Operating the garage door opener
Push the appropriate button to activate the
garage door opener. The indicator light
comes on. The garage door opener contin-
ues to send the signal as long as the
button is pushed (up to 20 seconds).
(c) Erasing the garage door opener
memory
Push and hold down the 2 outside buttons
for about 20 seconds until the indicator
light flashes. All memorized data will be
erased.
151