Toyota Sienna 2001 Operating Manual page 25

SWITCHING BEEP SOUND ON AND OFF
You can switch the beep on and off. (The
beep is on initially and after battery re-
placement.)
To switch the beep on and off:
With the driver's door opened—
1. Insert the ignition key and remove it.
2. Within 5 seconds, insert the ignition
key again and turn it to the "ON" posi-
tion.
3. After 10 seconds, push the same
"LOCK", "UNLOCK" or "PANIC" button
twice within 10 seconds.
Two beep sounds inform you that the
program has been switched on or off.
If this procedure is not followed exactly,
the beep will not operate as expected.
Check the beep ON/OFF operation by
pushing the wireless remote control trans-
mitter switch after you finish this proce-
dure. If the beep does not operate as
expected, repeat this procedure from step
1.
01 SIENNA_U (L/O0008)
Right side only power sliding door mod-
els
Left and right side power sliding door
models
2001 MY SIENNA (OM45406U)
"POWER DOOR", "D–PWR DOOR" AND
"P–PWR DOOR" SWITCHES (on some
models)
This switch of the wireless remote con-
trol transmitter is used to open and
close the power sliding door. Push the
switch slowly and securely.
To open: Push the switch. The sliding
door opens completely.
To close: Push the switch again. The slid-
ing door closes completely.
Opening and closing can be performed by
the "POWER DOOR", "D–PWR DOOR"
and "P–PWR DOOR" switches under the
following conditions only:
D
The sliding door is unlocked.
D
The power sliding door system is on.
(The "PWR DOOR OFF" switch is
pushed out.)
D
The ignition key is not in the "ON"
position.
Left and right side power sliding door
models—The left side power sliding door
does not operate when the fuel filler door
is opened.
25