Wireless Remote Control - Toyota Sienna 2000 Operating Manual

RESETTING THE POWER SLIDING
DOOR SYSTEM
If the power sliding door system operates
incorrectly or does not operate under the
following conditions, the system must be
initialized and reset by the steps in the
next column.
D
The battery is disconnected and then
reconnected, or a discharged battery is
recharged.
In this case, initialize and reset the
system by doing the following steps
from 6 to 10.
D
The open power sliding door warning
light stays on though the sliding door
is closed.
In this case, initialize and reset the
system by doing the following steps
from 1 to 10.
CAUTION
To initialize and reset power sliding
door system, stop the vehicle on a
level ground.
00 SIENNA(U)
1. Be sure to turn off the power sliding
door system by pushing in the "PWR
DOOR OFF" switch.
2. Disconnect the battery for 1 minute
and then reconnect it.
3. Close the sliding door by hand.
(Step 3 can be performed before step
2.)
4. Turn on the power sliding door system
by pushing out the "PWR DOOR OFF"
switch.
5. Wait 5 seconds.
6. Open the sliding door by using one of
the "PWR DOOR" switches.
7. Wait 3 seconds after the sliding door
stops at the fully- opened position.
8. Close the sliding door by using one of
the "PWR DOOR" switches or wireless
remote control transmitter.
9. Wait 3 seconds after the sliding door
stops at the fully- closed position.
10. Repeat the steps from 6 to 9.
If the power sliding door system does not
operate properly after the above proce-
dure, there may be a problem in the sys-
tem. Contact your Toyota dealer.

Wireless remote control

Locking operation
Unlocking operation
23