Toyota Corolla 2007 Operating Manual page 118

(l) Low Windshield Washer Fluid Level
Warning Light (for vehicles sold in
Canada)
The light warns that the windshield washer
fluid level is too low. Add washer fluid at
your earliest opportunity. (For instructions,
see "Adding washer fluid" on page 271 in
Section 7−3.)
(m) "VSC" Warning Light
The light warns that there is a problem
somewhere in the vehicle stability control
system or the traction control system.
The light will come on when the ignition
key is turned to "ON", and will go off after
about a few seconds.
If the light comes on, the vehicle stability
control system and traction control system
do not work. However, as conventional
braking operates when applied, there is no
problem to continue your driving.
In the following cases, contact your Toyota
dealer:
"
The light does not come on after the
ignition is turned to on.
"
The light is left on after the ignition is
turned to on.
"
The light comes on while driving.
110
'07 Corolla_U (L/O 0608)
The slip indicator light/traction control sys-
tem off indicator light will come on when
the "VSC" warning light comes on even if
the "TR A C OFF" switch is not pushed.
(n) Engine Oil Replacement Reminder
Light (for vehicles sold
U.S.A.)
This light reminds you when to replace
the engine oil.
This light will come on when the ignition
key is turned to "ON" and will go off after
about a few seconds.
When you drive for about 7200 km (4500
miles) after the engine oil replacement,
this light illuminates for 3 seconds and
then flashes for 12 seconds with the igni-
tion key turned to the "ON" position. If
you continue driving without replacing the
engine oil, and if the distance driven ex-
ceeds 8000 km (5000 miles), the light will
come on after the ignition key is turned
to the "ON" position. The light will remain
on thereafter.
If the light is flashing, we recommend that
you replace the engine oil at an early
opportunity depending on the driving and
road conditions.
The system must be reset after the en-
gine oil replacement. Reset the system by
the following procedure:
1. Turn the ignition key to the "ACC" or
"LOCK" position with
in the reading shown.
"Odometer and two trip meters" on
page 100 in this Section.)
2. Turn the ignition key to the "ON" posi-
tion while holding down the trip meter
reset knob.
Hold down the button for at least 5 sec-
onds. The odometer indicates "000000"
and the light goes off.
If the system fails to reset, the light will
continue flashing.
(o) Key Reminder Buzzer
This buzzer reminds you to remove the
key when you open the driver's door with
the ignition key in the "ACC" or "LOCK"
position.
(p) Light Reminder Buzzer
This buzzer will sound if the headlight
switch is left on and the driver's door is
opened with the key removed from the
ignition switch.
2007MY COROLLA from Oct. '06 Prod. (OM12B32U)
the odometer
(For details, see