Toyota Celica 2001 Operating Manual page 154

If your vehicle will not
start—
(a) Simple checks
Before making these checks, make sure
you have followed the correct starting pro-
cedure given in "How to start the engine"
in Section 3 and that you have sufficient
fuel.
If the engine is not turning over or is
turning over too slowly—
1. Check that the battery terminals are
tight and clean.
2. If the battery terminals are O.K., switch
on the interior light.
3. If the light is out, dim or goes out
when the starter is cranked, the battery
is discharged. You may try jump start-
ing. See "(c) Jump starting" for further
instructions.
If the light is O.K., but the engine still will
not start, it needs adjustment or repair.
Call a Toyota dealer or qualified repair
shop.
NOTICE
Do not pull– or push–start the vehicle.
It may damage the vehicle or cause a
collision when the engine starts. Also
the three–way catalytic converter may
overheat and become a fire hazard.
154
'01MY CELICA U (L/O 0008)
If the engine turns over at its normal
speed but will not start—
1. Turn the ignition key to "ACC" or
"LOCK" and try starting the engine
again.
2. If the engine will not start, the engine
may be flooded because of repeated
cranking. See "(b) Starting a flooded
engine" for further instructions.
3. If the engine still will not start, it needs
adjustment or repair. Call a Toyota
dealer or qualified repair shop.
2001 CELICA (20766U)
(b) Starting a flooded engine
If the engine will not start, your engine
may be flooded because of repeated
cranking.
If this happens, turn the key to "START"
with the accelerator pedal held down.
Keep the key and accelerator pedal so for
15 seconds and release them. Then try
starting the engine with your foot off the
accelerator pedal.
If the engine does not start after 15 se-
conds of cranking, release the key, wait
a few minutes and try again.
If the engine still will not start, it needs
adjustment or repair. Call a Toyota dealer
or qualified repair shop for assistance.
NOTICE
Do not crank for more than 30 seconds
at a time. This may overheat the starter
and wiring systems.