Specifications - Cary Audio Design SLP 98 Owner's Manual

SPECIFICATIONS

This section describes the basic specifications of the SLP 98 preamplifier at the time of printing.
Specifications are subject to change without notice or obligation. When the following cautionary terms
are used in this manual, these definitions apply:
WARNING
 Electrical hazard! Misuse or failure to follow instructions properly may result in personal
injury or death!
CAUTION
 No risk or personal injury; however, misuse or failure to follow instructions may result
in damage to equipment.
NOTE
 No risk of personal injury or equipment damage; however, misuse or failure to follow
instructions may prevent proper performance of the equipment.
........................................................................................................................................................
CIRCUIT
........................................................................................................................................................
INPUT IMPEDANCE
........................................................................................................................................................
OUTPUT IMPEDANCE
........................................................................................................................................................
GAIN
........................................................................................................................................................
RIAA CURVE
........................................................................................................................................................
SIGNAL/NOISE RATIO
........................................................................................................................................................
RESISTORS
........................................................................................................................................................
CAPACITORS
........................................................................................................................................................
POWER TRANSFORMER
........................................................................................................................................................
TUBES
........................................................................................................................................................
POWER SUPPLY
........................................................................................................................................................
AC POWER REQUIREMENTS
........................................................................................................................................................
WIRE
.......................................................................................................................................................
Class A Triode
47,000 ohms phono section with user option on lower resistance
800 ohms
1.2 millivolt input = 1 volt output phono stage = 43 dB
110 millivolt input = 1 volt output line stage = 20 dB
1,000Hz = 0dB
20Hz = +20dB
20,000Hz = - 20.5 dB
-88 dB
1% metal film
Polystyrene and polypropylene
200% duty cycle on all transformers enclosed in separate power
pack
2 - 6SN7 buffer cathode followers
2 - 6SN7 line stage
2 - 12AX7 (ECC83) phono section
2 - 12AU7 (ECC82) phono section output buffer
Full wave rectification, center-tapped, pi-network featuring a filter
choke
100/130 volts AC @ 50/60Hz
200/245 volts AC @ 50/60Hz
EE Teflon Silver
5