Beko TFF673APS Manual page 9

3.Gently prise off plastic hinge covers
on both sides of front top panel using
a small flat-headed screwdriver. (1-2)
4-Unscrew the bolts of the top hinge
and remove top hinge. (3)
5-Remove door carefully off the
bottom hinge and stand door upright
in a safe place.(4)
6.Gently prise off plastic hinge cover
on door top trim. Fit the other door top
trim plastic off hinge cover supplied in
the plastic bag.(5)
7.Gently tilt the appliance back
against a strong wall on its rear side
sufficiently to allow the lower hinge to
be removed. Take care to protect
the appliance, your wall and floor
coverings. You can utilise the original
packaging to do this.
you tilt the appliance back, check to
make sure the appliance is completely
stable and safe before you carry
on. (6)
8.Unscrew and remove the front feet
and 1 bolt. (7)
9-Unscrew and remove the bottom
hinge. (8)
10-Unscrew and remove the bottom
hinge door stopper and bushing and
reposition them on the other side while
rotating the bushing 180°. (9)
11- Fit the bottom hinge and tighten
the screws as shown in figure. (10)
12-Fit the other front feet as shown in
figure. (11)
13-Rotate the top hinge 180°.
Unscrew the hinge pin and re-tighten it
to the opposite side. (12)
14- Fit the top hinge on the left
hand side bushing of the door. (13)
15-Locate and re-fit door to bottom
hinge pin. (14)
16-Re-fit the upper hinge on the
opposite side by using a flat headed
screwdriver. (15)
17.Fit front top panel plastic hinge
covers on the opposite sides. (16)
18.
Remove the handle cover
gently taking care not to damage the
appliance.(17)
19.Unscrew and remove the handle
(18). Do not unscrew the yellow
coloured screws!
20. Rotate 180 degrees and fit
handle to the other side after removing
hole plugs gently.(19,20)
21 .Fit the handle cover.(21)
22-Adjust the two front feet if
necessary.
23-Check that door opens and closes
Once
easily, it is aligned correctly and there
are no gaps allowing air into the
cabinet. If there are gaps between the
door seal and the cabinet, adjust the
door seal by gently pulling away from
the door using fingers.
24-Check that all the hinge screws are
tightened. Avoid over tightening the
screws.
25-Put all items, fittings back in the
appliance.
26-Wait for at least 4 hours to allow
the system to settle before switching
on.
27-Once the correct storage
temperatures have been reached in
the appliance, put back all the food.
8
EN