Product View And Parts; How To Use - Rival 8704 Owner's Manual

KNOW YOUR ICE CREAM MAKER
PLASTIC BUCKET: 8704 (4 quart), 8706 (6 quart)
• MOTOR DRIVE
Top mounted. Engages stem of DASHER
and locks to bucket.
• RUBBER CORK
Used to plug hole in COVER
when hardening ice cream.
• COVER
Tab in COVER fits notch in ice cream can.
• DASHER
Stem on top fits through hole in center
of COVER, and engages MOTOR DRIVE.
• ICE CREAM CAN
Container holds ice cream mixture.
• DRAIN HOLE
Allows salt water to flow freely out
of BUCKET.
• BUCKET
MOTOR DRIVE tabs secure BUCKET. Drain hole located near top of
BUCKET. Holds rock salt and ice.
HOW TO USE YOUR ICE CREAM MAKER
NOTE: Before using for the first time, wash all parts except
MOTOR DRIVE (see "HOW TO CLEAN YOUR ICE CREAM MAKER").
1. Pour chilled ice cream mixture into cooled ICE CREAM CAN. Fill ICE
CREAM CAN only 3 / full, as mixture will expand during freezing.
4
2. Insert DASHER. Be sure that bottom of DASHER fits the indentation at
bottom of ICE CREAM CAN.
3. Place COVER on ICE CREAM CAN.
MOTOR DRIVE
RUBBER CORK
COVER
DASHER
ICE CREAM CAN
BUCKET SLOTS
BUCKET
-4-
For best results use Rival ® Rock Salt
ROCK SALT for making ice cream
ROCK SALT for hardening ice cream
CRUSHED ICE for making and hardening ice cream
4. Place filled ICE CREAM CAN in BUCKET. Make sure ICE CREAM CAN
is centered and engages with bottom of BUCKET.
5. Place MOTOR DRIVE over ICE CREAM CAN so that stem of DASHER
engages hole in bottom of MOTOR DRIVE. Rotate ICE CREAM CAN
slightly until MOTOR DRIVE engages ICE CREAM CAN COVER. Fit the
four tabs on the bottom of MOTOR DRIVE into holes at the top edge
of the bucket. Rotate the MOTOR DRIVE counter clockwise to secure
to bucket. Plug power cord into 120 volt AC outlet.
6. While ice cream maker is running, distribute 2 inches of ice around
bottom of BUCKET. Sprinkle approximately
over layer of ice. (See "Hints") NOTE: The DASHER does not move,
the ICE CREAM CAN turns around it.
7. Continue adding layers of ice, with salt between layers, until ice level
reaches top of rotating ICE CREAM CAN. NOTE: Should ice cream
maker stop before churning is complete (approximately 20-40
minutes), check to see if large ice cubes are jammed against the
rotating ice cream can. (See "Important Points")
8. Ice cream should churn about 20-40 minutes or until motor stops.
Unplug and remove MOTOR DRIVE.
9. Clear ice and salt away from top of ICE CREAM CAN. Wipe carefully
to remove salt and water before removing the COVER. Lift out
DASHER and scrape clean with a rubber spatula. Pack ice cream
down into ICE CREAM CAN.
MAKER SIZE
4 Quart 6 Quart
3 Cups 4 Cups
2 Cups 3 Cups
17 lbs. 25 lbs.
1 / cup salt uniformly
4
-5-