Rival S16 Owner's Manual page 4

HOW TO ASSEMBLE YOUR ELECTRIC SKILLET
Remove all parts from the packaging.
ASSEMBLING LID HANDLE
1. Find LID and LID HANDLE.
2. Holding LID HANDLE on the outside
top of LID, align holes in lID HANDLE
into holes located on the outside of
the LID. Handle should be centered
over glass in the LID.
3. Place the phillips head screws through
screw holes on the inside of the LID
(2 places).
4. Tighten screws with a screwdriver until
snug. Screws should be seated flush against
LID surface. The LID is now ready for use.
ASSEMBLING SIDE HANDLES/LEGS
1. Place pan upside down on table.
2. Find one SIDE HANDLE/LEG and mount on the pan side where the probe
connects to the pan.
3. Align screw holes in SIDE HANDLE/LEG over the screw posts on pan
(2 places per handle).
4. Insert screws (2 per handle) through holes in bottom of SIDE HANDLE/LEG
and align screws in holes in the pan.
5. Tighten screws with a screwdriver until snug. Screws should be seated flush
against handle.
6. Repeat steps 3 through 5 with the other SIDE HANDLE/LEG.
7. Once both handles are tightened securely, place skillet upright onto its legs.
Assembly is complete.
CAUTION: Do not operate skillet prior to assembly of SIDE HANDLES/LEGS and
LID HANDLE.
IMPORTANT
Check the SIDE HANDLES/LEGS of your skillet periodically for looseness. If
needed, re-tighten with a screwdriver. CAUTION: Overtightening can result in
stripping of screws or cracking of handles and base.
-4-