Washing And Drying Options - Bosch WKD28540EE Installation And Operating Instructions Manual

Washing and drying options

°C
(Temperature)
button
B (Spin speed)
Rinse hold
Unbalanced load detection
system
Menu button
Selec. button
Options (symbols on the display panel)
!
Pre-wash
X Intensive
Q Easy-iron
Z
Water Plus
Flexi Time
R
P Signal
0 Finished in button
The temperature can be adjusted individually for each programme.
button
To adjust it, press the °C (Temperature) button repeatedly until the
required temperature is displayed.
The spin speed can be individually adjusted for each programme.
To set the spin speed, press the B (Spin) button repeatedly until the
required spin speed is displayed.
$ (Rinse hold) deactivates the spin function. The laundry remains in the
rinsing water.
The automatic unbalanced load detection system ensures that the laundry
is evenly distributed using several initial spins. If the laundry is extremely
unevenly distributed, the speed of the final spin is reduced or the spin
cycle is not performed for safety reasons.
The set programmes can be individually adjusted.
To choose the required option:
 Press the menu (Option) button repeatedly until the required option is
selected (indicator lamp flashes).
 Press the selec. (Set) button to switch the option on/off (indicator lamp
lights up/does not light up).
i
If you press and hold the menu (Option) ~ button, all the options scroll
through.
Prewash at 35 °C. Suitable for heavily soiled laundry.
Prolonged washing time. Suitable for particularly heavily soiled laundry
with dried-on stains. Cannot be combined with R Flexi Time
Special spin sequence with subsequent fluffing. Gentle final spin at
reduced speed. Slightly increased residual moisture in the laundry.
Reduces creasing and laundry is easier to iron.
Increased water level and additional rinse cycle. For regions with very soft
water or for further improving the rinsing result. Any detergent residues
are removed.
Sets the washing time. normal-medium-short.
Activates or deactivates the audible signal.
You can postpone Programme start before it begins. Using the Remaining
time, you can determine when the selected programme is to end. The
remaining time can be set in one-hour increments, up to a maximum of
24 hours. Press the 0 (Finished in) button repeatedly until the required
number of hours is displayed.
Then press the A (Start/Pause) button, the programme will start after a
delay according to the set Remaining time. The required time to the end
of the programme is shown on the display panel.
13