BMW Motorrad K 1300 GT Rider's Manual page 127

Install securing screws 2 on
left and right and tighten to
specified tightening torque.
Front brake caliper to
wheel carrier
30 Nm
Clip on the two retaining
clips 1 holding the ABS sensor
cable to the brake line.
Remove the adhesive tape
from the wheel rim.
Firmly pull the handbrake lever
until the pressure point is per-
ceptible, and repeat this opera-
tion several times.
Hold the front-wheel cover in
position and install bolts 1 on
left and right.
Removing rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
8
123
z