RAM CV 2013 Owner's Manual page 96

Cargo van
Hide thumbs Also See for RAM CV 2013:
Table of Contents

Advertisement

WHAT TO DO IN EMERGENCIES
- Electronic Throttle Control (ETC) Indicator Light
• This light informs you of a problem with the system.
• If a problem is detected, the light will come on while the engine is running. Cycle
the ignition when the vehicle has completely stopped and the shift lever is placed
in the PARK position; the light should turn off.
• If the light remains lit with the engine running, your vehicle will usually be
drivable; however, see an authorized dealer immediately. If the light is flashing
when the engine is running, immediate service is required and you may experience
reduced performance, an elevated/rough idle or engine stall and your vehicle may
require towing.
- Air Bag Warning Light
• If the light is not on during starting, stays on, or turns on while driving, have the
vehicle serviced by an authorized dealer immediately.
Fuel Cap/Loose Gas Cap Message
• If a "gas cap" message (shown as gASCAP) appears, tighten the gas cap until a
"clicking" sound is heard.
• Press the odometer reset button, located below the tachometer, to turn the
message off.
• If the message continues to appear for more than three days after tightening the
gas cap, see your authorized service center.
"CHANGE OIL" MESSAGE
• If a "Change Oil" message appears and a single chime sounds, it is time for your
next required oil change.
Resetting The Light After Servicing
Vehicles Equipped With Keyless Enter-N-Go™
• Without pressing the brake pedal, push the ENGINE START/STOP button and
cycle the ignition to the ON/RUN position (Do not start the engine.)
• Fully depress the accelerator pedal, slowly, three times within 10 seconds.
• Without pressing the brake pedal, push the ENGINE START/STOP button once to
return the ignition to the OFF/LOCK position.
Vehicles Not Equipped With Keyless Enter-N-Go™
• Turn the ignition switch to the ON/RUN position (Do not start the engine.)
• Fully depress the accelerator pedal, slowly, three times within 10 seconds.
• Turn the ignition switch to the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this procedure.
94

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ram cv cargo van 2012

Table of Contents