Activation - Mazda navigation system Owner's Manual

Activation

Insert the map disc into the unit to start the Mobile Navigation System.
n
Cautions
Note
lThe map disc cannot be inserted or ejected while the ignition switch is in the OFF position.
lRemember that the battery can run down if the ignition switch is kept in the ON or ACC
position for a long time while the engine not running.
1
Turn the ignition switch
to the ON position and
press
the display.
2
Insert the map disc
with the printed side
facing up.
14
Map Disc
l
Refer to "Handling and Care of Map Discs" to know how to handle a map
disc ( page 58).
to open
OPEN
Note
lThis display angle can be adjusted by pressing
lPress
to close the display.
OPEN
Note
lThe main unit is located in the glove box
compartment. (Mazda 3)
lThe main unit is located in the Center Console (Rear).
(Mazda RX-8)
lCondensation may form on the optical lens or the
map disc inside the unit when the temperature in
the vehicle increases in a short time such as when
heating the car on a cold day. This condensation
may cause malfunctions. If so, unload the map disc
and do not operate the unit for approximately 1
hour. Wipe the condensation off the map disc with a
soft cloth.
If the unit does not operate correctly after 1 hour,
consult an Authorized Mazda Dealer.
.
TILT
When the is
TILT
pressed, the display
angle changes in
stages.
(CAUTION) screen