Advertisement

NOTE 2014 INSTALLATION SUPPLEMENT STARTS ON PAGE 9
GENUINE CAR-NAVIGATION UNIT

INSTALLATION INSTRUCTIONS

Thank you for purchasing a genuine Mazda accessory.
Before removal and installation, be sure to thoroughly read these instructions.
Please read the contents of this booklet in order to properly install and use the
car-navigation unit. Your safety depends on it.
Keep these instructions with your vehicle records for future reference.
• There are several
safety when installing or removing the car-navigation unit. Always read and follow them
in order to prevent injuries, accidents, and possible damage to the vehicle.
WARNING: Indicates a situation in which serious injury or death could result if
the warning is ignored.
CAUTION: Indicates a situation in which bodily injury or damage to the vehicle
could result if the caution is ignored.
• For areas indicating the tightening torque in this instruction manual, tighten to the
specified torque using a torque wrench. For areas in which the tightening torque is
indicated inside parentheses ( ), the tightening torque is indicated as a reference value,
however tightening using a torque wrench is not necessary.
• Do not modify the car-navigation unit.
• Do not install the car-navigation unit in any way other than described in the following
instructions.
• If in any doubt, please ask your Mazda dealer to install the accessory in order to
prevent errors in installation.
• If you have any questions about the use of the accessory, ask your Mazda dealer for
proper advice before using it.
• Mazda and its suppliers are not responsible for injuries, accidents, and damage to
persons and property that arise from the failure of the dealer or installer to follow these
instructions.
To ensure safety and reliability of the work, installation, removal and disposal work
must be carried out by an Authorized Mazda Dealership.
Be careful not to lose removed parts, and be sure that they are kept free from
scratches, grease or other dirt.
PART NUMBER: KF69 79 EZX
NOTE
To the dealer
• Please turn over these instructions to the customer after installation.
To the customer
• Keep these instructions after installation. The instructions may be necessary
for installing other optional parts or removal of this accessory.
• Should the vehicle or this accessory be resold, always leave these instructions
with it for the next owner.
WARNING
WARNING and
CAUTION sections in this booklet concerning
PART NAME: CAR-NAVIGATION UNIT
KD37 79 EZX
VEHICLE: MAZDA CX-5
1
(MEXICO)
(US/CANADA)
00
GB
00
00
F
00
00
E
00

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KF69 79 EZX and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Mazda KF69 79 EZX

  • Page 1: Installation Instructions

    • Do not install the car-navigation unit in any way other than described in the following instructions. • If in any doubt, please ask your Mazda dealer to install the accessory in order to prevent errors in installation. • If you have any questions about the use of the accessory, ask your Mazda dealer for proper advice before using it.
  • Page 2: Before Installation

    ▼ PARTS LIST NOTE: • Before installation, verify that the kit includes all the following parts and that they are free of dirt, scratches, or damage. • KF69 79 EZX (MEXICO), KD37 79 EZX (US/CANADA) Part Part name Qty. Part Part name Qty.
  • Page 3: Installation

    3. VEHICLE PARTS REMOVAL Negative battery cable disconnection 1. Set the selector lever to P range. Negative battery cable (AT vehicles only) WARNING • When removing/installing the parts, park the vehicle on level ground and apply the side brake securely. Be sure to turn the ignition switch off, otherwise the vehicle can move, causing personal injury or vehicle damage.
  • Page 4: Operation Check

    Car-navigation unit Installation GPS antenna Car-navigation unit connector 1. Connect the USB, GPS antenna, and +B/ACC connectors to the car-navigation unit. +B/ACC connector 2. Install the wiring harness clip. connector Harness clip 3. Press the clips (4 locations) shown in the figure and install the Car-navigation unit Lower panel car-navigation unit to the lower panel.
  • Page 5 Press the POWER/VOLUME dial to switch to the on screen. POWER/VOLUME dial Audio on screen Press the POWER/VOLUME dial and SEEK UP button at the SEEK UP button same time on the Audio on screen (press POWER/VOLUME dial a little earlier). POWER/VOLUME dial After switching to the AUDIO system screen, touch the buttons in the order of “1”, “5”...
  • Page 6 Connection verification of +B/ACC connector and USB connector Audio off screen Turn the ignition switch to the ON position. When the Audio off screen is displayed after the opening screen ends, press the NAV button. NAV button When the screen in the figure on the left is displayed, the connection verification is completed.
  • Page 7 3. Pull up the power window switch to close the window and continue to pull it up for about two seconds after it is fully closed. 4. If the feature does not function even after the ignition switch is turned off, contact an Authorized Mazda Dealer.
  • Page 8 CAR-NAVIGATION INSTALLATION MAZDA INSPECTION CX-5 UNIT SHEET KF69 79 EZX (MEXICO) KD37 79 EZX (US/CANADA) A. Vehicle parts reinstallation • Install removed vehicle parts in the reverse order of “VEHICLE PARTS REMOVAL”. Check CAUTION • Make sure that the vehicle parts are clean before reinstalling. Clean any dirty parts.
  • Page 9 • Do not install the car-navigation unit in any way other than described in the following instructions. • If in any doubt, please ask your Mazda dealer to install the accessory in order to prevent errors in installation. • If you have any questions about the use of the accessory, ask your Mazda dealer for proper advice before using it.
  • Page 10 1. INSTALLATION GPS CONNECTOR INSTALLATION(US/CANADA only) Hook A Glove compartment removal 1. Push the glove compartment in the direction of the arrow (1) and hooks A. 2. Pull the stay damper in the direction of the arrow (2) shown in the figure and remove the hook B.
  • Page 11 USB connector (Pg. 6)” of “5. OPERATION CHECK” of current INSTALLATION INSTRUCTIONS (KD37 79 EZX/KF69 79 EZX), and is implemented only if the “Continue” button is pressed by mistake and the screen advances too far. 1. Touch "No”...
  • Page 12 7. Touch “Setting”. 8. Touch the location shown in the figure. 9. Touch “Reset factory setting”. 10. Touch “Yes”. 11. Touch “Yes”. 12. Setting is finished when “Welcome” screen appears. 13. Switch the ignition off.
  • Page 13 CAR-NAVIGATION INSTALLATION MAZDA INSPECTION CX-5 UNIT SHEET GJY3 79 EZX (MEXICO) KJY2 79 EZX (US/CANADA) A. Vehicle parts reinstallation • Install removed vehicle parts in the reverse order of “VEHICLE PARTS REMOVAL”. Check CAUTION • Make sure that the vehicle parts are clean before reinstalling. Clean any dirty parts.

This manual is also suitable for:

Kd37 79 ezx

Table of Contents