Mercedes-Benz SLK 350 Operator's Manual page 269

Step 4:
Continue to press and hold integrated
signal transmitter button (1, 2
or 3) while you press and re-press
("cycle") your hand-held remote con-
trol transmitter 6 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp 4 will flash slowly and
then rapidly after several seconds.
Proceed with programming step 5 and
step 6 to complete.
Operation of integrated remote control
Switch on the ignition.
Select and press appropriate integrat-
ed signal transmitter button (1, 2
or 3) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Controls in detail
Useful features
Erasing the integrated remote control
memory
Switch on the ignition.
Simultaneously hold down signal trans-
mitter buttons 1 and 3, for approxi-
mately 20 seconds, until the indicator
lamp 4 blinks rapidly. Do not hold for
longer than 30 seconds.
The codes of all three channels are
erased.
i
If you sell your vehicle, erase the codes
of all three channels.
269