Marathon RJ-88SC User Manual page 37

HAULER INSTRUCTIONS - HYDRAULIC TAILGATE OPERATION
The truck hoist must have a hydraulic selector valve with 1500 psi, min. to operate the
hydraulic tailgate. The hydraulic tailgate is supplied with one 1/2" NPTF male quick dis-
connect mounted on the drivers side of the unit. A 1/2" female quick disconnect is sup-
plied for use on the truck hoist valve plumbing.
CAUTION
STAND CLEAR OF TAILGATE WHEN LIFTED.
*
TRUCK MUST BE ON FIRM, LEVEL SURFACE BEFORE LIFTING TAILGATE.
*
FRONT AND REAR HOLD DOWNS MUST BE ENGAGED.
*
TILT HOIST BEFORE LIFTING TAILGATE.
*
1.
ATTACH HYDRAULIC
CONNECTION.
DISENGAGE LATCH.
2.
(EACH SIDE)
3. RAISE HOIST.
4. LIFT TAILGATE.
5. EMPTY CONTENTS.
6. CLEAN SEAL AS DESCRIBED IN THE "HAULER INSTRUCTIONS - GENERAL" IN THIS SECTION
OF THE MANUAL. NOTE WARNINGS.
7. LOWER TAILGATE AS LOW AS POSSIBLE.
8. LOWER HOIST.
9. LOWER TAILGATE COMPLETELY.
10. ENGAGE AND TIGHTEN LATCHES.
11. REMOVE HYDRAULIC CONNECTION.
(FOR OPTIONAL HT UNITS)
CONTAINER/COMPACTOR
TRUCK HOIST
TRUCK HOIST
4 HAULER INFORMATION
4-3
DANGER
STAND CLEAR OF
TAILGATE
WHEN LIFTED
06-0105
LATCH
TAILGATE
CONTENTS