American DJ REVO RAVE User Instructions page 4

Revo Rave™ System Menu Revo Rave™ System Menu
System Menu: When making adjustments you can press
ENTER to confirm your setup or you can wait 8 seconds for
automatic setup. To exit without making any adjustments
press the MENU button.
ADDR -
DMX Address Setting.
1. Tap the either the MENU, UP, or DOWN buttons until "ADDR"
is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press
the UP or DOWN buttons to find your desired address. Press
ENTER to set your desired DMX address.
SLND -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Tap the MENU button until "SLND" is displayed, press ENTER.
Either "MAST", "SL 1" or "SL 2" will be displayed.
2. Tap the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
NoTE: In a Master/Slave configuration you can set one fixture
to Master and then set the next fixture to "SL 2", the fixtures will
now have contrast movement to each other.
SHND: SH 0 - 12
- Show modes 0-12 (Factory programs). For
show mode to run properly, make sure sound active mode is
off.
1. Tap the MENU button until "SHND" is displayed, press ENTER.
2. "Sh X" will now be displayed, "X" representing a number
between 0-10. Programs 1-12 are factory programs, while "Sh
0" is random mode. Press the UP or DOWN buttons to find your
desired show and press the ENTER, then press and hold the
MENU button for at least 3 seconds to confirm.
American DJ Supply - www.americandj.com - Revo Rave™ User Manual Page 7 American DJ Supply - www.americandj.com - Revo Rave™ User Manual Page 8
© ® © ®