Download Print this page

Samson TXM20 Product Specification Sheet page 2

20 channel 1000w powered mixer
Hide thumbs Also See for TXM20:

Advertisement

PRODUCT SPECIFICATION SHEET
SERIES
DESCRIPTION
TXM20
20 CHANNEL 1000W POWERED MIXER SIGNAL PROCESSING
FEATURES
(continued)
1000-watt power amplifier section, featuring three modes
>
of operation; 2 x 500-watts Stereo Main, or 500-watt
Mono Main/500-watt Monitor, or 1000-watts Bridged
Ample inputs, the TXM20 has twelve mic/line inputs plus
>
four stereo line inputs.
Two Built-in, 24-bit DSP (Digital Signal Processor) Multi-
>
effects Processors with 100 selectable presets each
offering dazzling studio quality effects including Reverb,
Delay and Chorus and Flanging.
The TXM20 mixer features high-quality, low-noise
>
microphone pre-amplifiers that can accept signal from any
standard microphone. With the mixer's XLR connectors,
connecting standard low impedance dynamic mics is
simple, and condenser microphones are connected easily
using the available 48 Volt Phantom Power.
489mm
FRONT
ARCHITECT'S & ENGINEER'S SPECIFICATIONS
The Samson TXM20 shall be a 20 channel stereo powered
mixer. There shall be 12 mic/line channels and 4 stereo
channels. All mono channels shall have XLR inputs with
phantom power, Peak LED's, 1/4 inch line inputs, insert
points, trim controls, high pass filters, 3 band EQ with
sweepable mids, 2 aux sends for moitors and 1 aux for the
onboard DSP, pan, mute, PFL and 60mm faders. Stereo
channels 13-16 shall have all the same controls except for
XLR inputs, insert points, High Pass and sweepable mids.
Channels 17-20 shall have aux sends 1 and 2, PFL, and level
only. The onboard DSP's shall have 100 presets with aux 1
and 2 controls to add effects to monitors. The main section
shall have Aux 1 and 2 send faders, CD/Tape input fader,
Mono output/sub fader, and main level fader. There shall
be a channel 1-12 mute switch. There shall be a subwoofer
crossover in/out switch with frequency control for the mono/
sub output. There shall be an 11 segment LED ladder for
main level or AFL/PFL. There shall be a 9 band stereo graphic
EQ for the main outputs and a 9 band graphic EQ for the
monitors. There shall be a power amplifier capable of 2 x 500
watts @ 4 ohms or 1000 watts @ 8 ohms bridged mono.
CATEGORY
TXM16 SPECIFICATIONS
Rated Output power .......................... 2 X 500W at 4Ω @0.1%
Frequency response .......................... 20Hz~20KHz+/-0.7dB@1W
Total Harmonic Distortion .................. Less than 0.06% @ 20Hz~
HUM & Noise ................................... -121dB equivalent input noise
(Average, RS+150Ω) ......................... -100dB residual output
144.76mm
(with 22Hz~22KHz BPF) .................... -79dB (MAIN OUT, AUX
Maximum Voltage Gain ...................... 67dB CH IN (MIC) to AMP OUT
Crosstalk 1KHz ................................ 70dB adjacent input, 70dB
SIDE
Input Channel Equalization
Meters ............................................ 11 POINT LED METERS (-20, -15,
Graphic Equalizer ............................. 9 bands (63, 125, 250, 500,
Internal DSP Effects ......................... 24 BIT - 10 Presets each: 1-
Phantom Power ................................ +48V
CLIP Indicators ................................ Turn on: THD> 0.1%
Foot Switch ..................................... DIGITAL EFFECT MUTE: ON/OFF
Power Requirement .......................... 110V/60 Hz, 240V/50Hz
Power Consumption .......................... 1900W, MAX.
Weight ............................................ 50.6 lbs./23Kg
Dimensions (W x H x D) .................... 24 1/2" x 6 1/4" x 21"
63dB CH IN (MIC) to MAIN OUT, MONITOR OUT
54dB CH IN (MIC) to AUX 2 OUT
30dB CH IN (MIC) to REC OUT
32dB CH IN (LINE) to MAIN OUT, MONITOR OUT
26dB AUX IN to MAIN OUT
24dB TAPE IN to MAIN OUT
HIGH ................................. 12KHz shelving (+/- 15dB MAX)
MID ................................... variable 100 Hz to 8kHz
LOW .................................. 80Hz shelving (+/- 15dB MAX)
TXM20
THD at 1KHz, 1 X 1000W at
8Ω Bridged
Output into 8Ω (AMP OUT)
20 Hz~20KHz+/-0.4@+4dB
Output into 10kΩ (MAIN
OUT, MAIN OUT 2, AUX OUT,
AUX SEND, EFX OUT)
20KHz, 75W output into4Ω
(SPEAKER OUT); Less than
0.1%@20 Hz~20KHz+4dBu
output into 10KΩ (MAIN
OUT, MAIN OUT 2, AUX OUT,
EFX OUT)
noise (MAIN OUT, AUX OUT,
EFX OUT)
OUT) Master level control at
maximum, all channel level
control at minimum.
-79dB (EFX OUT) Master level
control at maximum, all channel
level controls at minimum.
input to output
peaking (+/- 15dB MAX)
-10, -7, -5,-3, 0, +1, +2, +4, +6dB)
1K, 2K, 4K, 8K, 16KHz)
Performance; 2-Hall Reverb,
3-Plate Reverb; 4-Spring
Reverb; 5-Echo; 6-Flange +
Verb; 7-Chorus + Verb; 8-Echo
+ Verb; 9-Chorus; 10-Flange
(Country Specific)
622mm x 159mm x 533mm

Advertisement

loading