Table of Contents
Advertisement
^ Push the appliance into its
building-under niche.
^ Align the appliance so that the front
edges of the hinges at the top and
bottom are flush with the front edge
of the housing unit side wall.
This will create a gap all round of
42 mm to the front edges of the
housing unit side walls.
On furniture with door fittings (e.g.
stubs, seals etc) the dimension of
these must be taken into account when
making sure there is a gap all round of
42 mm.
^ Pull the appliance forwards by the
dimension of the door fitting to keep
the gap at 42 mm all round.
The hinges will now protrude by the
dimension of the door fitting.
Tip: Remove the door fittings. This will
ensure that the door is flush with the
surrounding kitchen unit furniture doors.
If the all round gap of 42 mm is not
maintained between the appliance
casing and the front edge of the
housing unit side walls the door may
not shut properly.
This could lead to a build-up of ice
and condensation and also cause
operational faults.
Building in the appliance
39
Advertisement
Table of Contents
