Storage; Specifications - Echo SMR-2400SB Operator's Manual

14
S
TORAGE
1. Clean ProSweep attachment bristles with water.
IMPORTANT
Do not immerse this attachment in water. Water will enter gear
housing and damage gears, bearings and seals.
2. Apply thin coating of oil to metal parts to prevent rust.
3. Lubricate lower shaft assembly with grease. (Refer to Lubrication
instructions.)
4. Store ProSweep attachment in a dry place out of reach of children.
Do not store attachment with the weight resting on brushes which
could bend over a long period of time. Store attachment with lower
shaft housing in a horizontal or vertical position to prevent grease
loss from open shaft end.
Storage Hook Installation
5. Insert small end of hook into locating hole on attachment shaft.
6. Slide plastic cap onto end of attachment shaft.
S
PECIFICATIONS
ProSweep Attachment : Approved for use on PAS and Split Boom Models
Attachment Length ---------------------------------------- 927 mm (36.5 in.)
Attachment Width ----------------------------------------- 597 mm (23.5 in.)
Attachment Height ---------------------------------------- 279 mm 11 in.)
Weight ------------------------------------------------------ 5.1 kg. (11.25 lb.)
Drive Shaft -------------------------------------------------- 6.35 mm (0.25 in.)
Rotating Direction ----------------------------------------- Towards the operators viewed from the rear
Brushes ----------------------------------------------------- Standard 0.7 mm (0.028 in.) Nylon Bristles Optional 0.5 mm
Max Sweeping Width ------------------------------------- 571 mm (22.5 in.)
Lubrication -------------------------------------------------- Lithium Base Grease
Gear Reduction Ratio -------------------------------------- 40 : 1
Sweeper Operating (RPM) -------------------------------- 200
Engine Wide Open Throttle (RPM) w/attachment ----- 7700-8500
(0.018 in.) Nylon Bristles