Homelink Universal Transceiver - Honda 2007 Pilot Owner's Manual

If equipped
The HomeLink universal
transceiver built into your vehicle
can be programmed to operate up to
three remotely controlled devices
around your home, such as garage
doors, lighting, or home security
systems.
General Information
If you are training HomeLink to
operate a garage door or gate, you
should unplug the motor for that
device during training. Repeatedly
pressing the remote control button
could burn out the motor.
HomeLink stores the code in a
permanent memory. There should
be no need to retrain HomeLink if
your vehicle's battery goes dead or is
disconnected.
If your garage door opener was
manufactured before April 1982, you
may not be able to program
HomeLink to operate it. They do not
have the safety feature that causes
the motor to stop and reverse if an
obstacle is detected during closing,
increasing the risk of injury.
Important Safety Precautions
Always refer to the opening
instructions and safety information
that came with your garage door
opener or other equipment you
intend to operate with HomeLink. If
you do not have this information,
contact the manufacturer of the
equipment.
For quick and accurate training,
make sure the remote transmitter
for the device (garage door,
automatic gate, security system, etc.)
has a fresh battery.

HomeLink Universal Transceiver

Training HomeLink
If you just
Before you begin
received your vehicle and have not
trained any of the buttons in
HomeLink before, you should erase
any previously learned codes before
training the first button. To do this,
press and hold the two outside
buttons on the HomeLink
transceiver for about 25 seconds,
until the red indicator flashes.
Release the buttons, then proceed to
step 1.
If you are training the second or
third buttons, go directly to step 1.
1. Unplug the garage door opener
motor from the electrical outlet.
2. Hold the end of the garage door
opener remote transmitter 2 to 5
inches from HomeLink. Make
sure you are not blocking your
view of the red indicator in
HomeLink.
CONTINUED
181