Cmos Rtc & Isa Cfg Cmos Sram; Speaker Connector Installation; Hardware Reset Switch Connector Installation; Power Led Connector Installation - Gigabyte 6BXD User Manual

Intel dual pentium ii processor based pc / at compatible mainboard.

Hide thumbs Also See for 6BXD:

Table of Contents

6BXD

3.6. CMOS RTC & ISA CFG CMOS SRAM

There're RTC & CMOS SRAM on board; they have a power supply from

external battery to keep the DATA inviolate & effective. The RTC is a REAL-

TIME CLOCK device, which provides the DATE & TIME to system. The

CMOS SRAM is used for keeping the information of system configuration, so

the system can automatically boot OS. every time. Due to the life-time of

Battery internal battery is 5 years, the user can change a new Battery to

replace old one after it can not work.

M Danger of explosion if battery is incorrectly replaced.

M Replace only with the same or equivalent type recommended by the

manufacturer.

M Dispose of used batteries according to the manufacturer's instructions.

There is always a speaker in AT system for sound purpose. The 4 - Pins

connector J11 is used to connect speaker.

The speaker can work well in both direction of connector when it is installed

to the connector J11 on mainboard.

The RESET switch on panel provides users with HARDWARE RESET

function, which is almost the same as power-on/off.

The system will do a cold start after the RESET switch is pushed and

released by user. The RESET switch is a 2 PIN connector and should be

installed to J10 on mainboard.

There are system power LED lamps on the panel of case. The power LED

will light on when system is powered-on, which is connected to a 3 PIN

connector.

The connector should be connected to JP7 of mainboard in correct direction.

3-7

Table of Contents