Cobra MT 975 User Manual page 7

10376 MT975UK.qxd
MODE FUNCTIONS
While setting privacy code scan, if you do not
press any buttons for 15 seconds your radio will
automatically return to LISTENING MODE on
the channel/privacy code that was displayed
before you entered MODE functions.
During An Incoming Transmission,
You Can Choose From The Following:
a. Press and hold the TALK button to
communicate on that channel/privacy code.
Your radio will remain on that channel/privacy
code and return to LISTENING MODE.
b. Press the CHANNEL UP or CHANNEL DOWN
button to resume scanning privacy codes.
If you press the TALK button while scanning,
but more than 10 seconds after receiving a
transmission, you will transmit on the privacy
code on which, during scanning, you last received
a transmission.
If you do not press any button within 10 seconds,
your radio will automatically resume scanning
privacy codes.
Memory Location Scan
Your microTALK ® radio can automatically scan up to
10 programmed Memory Locations.
NOTES: If there are one or fewer memory locations
programmed in your radio, the scan
memory locations option will not be
available. To program at least two memory
locations, see program memory locations.
To Scan Memory Locations:
1. Press the MODE button
until the Scan icon,
Memory icon and the
memory location number
flash on the display.
2. Press the CHANNEL UP or CHANNEL DOWN
button to begin scanning memory locations.
The Scan icon and the Memory icon will continue
to be displayed when memory location scan is ON.
Your radio will continue to scan memory locations
and stop if an incoming transmission is detected.
Your radio will remain on that memory location for
10 seconds.
While setting memory location scan, if you do not
press any buttons for 15 seconds, your radio will
automatically return to LISTENING MODE on the
channel/privacy code displayed before your entered
MODE functions.
1/15/08 4:05 PM
During Memory Location Scan (While
Receiving An Incoming Transmission),
You Can Choose From The Following:
a. Press and hold the TALK button to
communicate on that memory location.
b. Your radio will remain on that memory
location and return to LISTENING MODE.
Press the CHANNEL UP or CHANNEL DOWN
button to resume scanning memory locations.
If you press the TALK button while scanning,
but more than 10 seconds after receiving a
transmission, you will transmit on the memory
location on which, during scanning, you last
received a transmission.
VibrAlert and Call Alert
Your microTALK
signals by sounding an audible call tone, by
vibrating silently or both.
To Change Call Settings:
1. Press the MODE button until
the Call Settings icon flashes
on the display. The current
setting ("01" vibrate + tone,
"02" vibrate only or "00"
Scanning Locations
tone only) is displayed.
2. Press the CHANNEL UP or
CHANNEL DOWN button to
change the call setting.
3. Choose one of the following:
a. Press the MODE button to
enter the new setting and
proceed to other
functions.
b. Press the LOCK/ENTER
button to enter the new
setting and return to
LISTENING MODE.
Page 7
English
® radio can alert you to incoming
VibrAlert + Tone
VibrAlert Only
Tone Only