19-20 Technical Data ……………………………...…………… Thank you for selecting Steam Planet Corp Computerized Steam Room, we hope that our exquisite design will meet your life’s needs; it’s our honor to promote your health and longevity with comfortable enjoyment. In order to operate and use the product well, please read carefully and follow all instructions provided in this User’s Manual.
GENERAL INFORMATION Units come broken down in panels and are assembled with screws, nuts and bolts on site. All seams & joints to be caulked with 100% silicone at room temperature (no latex caulking) Note: All shower bases need to be leveled in its final resting position, mark the placement, then pull base out and begin assembly.
Voltage Power Frequency Length Width Height M-A021 220V 2.5kW 50~60Hz Drain Disclosure NOTE: a flexible drain hose is provided with the unit. We strongly recommend taking off the flex drain hose and hard pipe the unit into existing drain. This will not void the warranty. Call 866- STEAM-61 for any questions.
Attention: do not put anything in the safe area, the distance between the top shower cover and ceiling should be greater than the safe area. Room must be left clear on both sides of the shower. Tools Needed for Installation P a g e REV 03/2012...
Packing List 1. Check the unit as soon as it arrives. Note if there is any shipping damages, then notify the distributor. 2. Check the water and the electronic system and ground are suitable for installation. 3. At least two people will be needed for installation. 4.
Installation 1. Connect the shower hose with shower outlet (on the back panel), then put the hand- held shower on the sliding bar. 2. When using the foot massage, open the cover first. P a g e REV 03/2012...
Page 9
3. Put the shower tray on the selected area (using are of this product), check whether it is leveled, then adjust the foot screws (under the shower tray) to make sure it is leveled. Note: level all feet on the supporting bar. 4.
Page 10
5. Place all the glass onto the acrylic shower base. 6. Place the roof of the unit on top of all glass and attach it with ST4x10 to glass doors; M6x25 screws are used to attach top with control column and shower tray. 10 | P a g e REV 03/2012...
Page 11
7. Attach shelf and rail as shown. 8. Connect the pipes in the package with the drain outlet on the steam generator and the drain exit; fasten it with the M4X16 round head screw; as shown. 9. Pull the top shower pipe through hole on the top cover. Connect to the shower head. 11 | P a g e REV 03/2012...
Page 12
Please, refer to the labels on the wires; connect the wires sharing the same sign. Connect the braided cold and hot water hoses, the red one is for hot water, blue is for cold. Seal the connection with Teflon tape. 220V 50-60Hz 12 |...
Page 13
After connecting the hot and cold water, rotate the temperature knob, in accordance with the temperature scale in the dial, you can adjust the different temperature, rotate the middle knob, this shuts the water on and off. Rotate the water diverter function knob;...
Troubleshooting Guide Situation Malfunction Possible Failure Reason Solutions Display 1. Power line not connected or no 1. Correctly connect or wait for the power supply electricity supply to resume. No display on the 2. Insufficient power 2. The power must reach the required Will not run monitor 3.
Replacing Door Rollers 1. Remove plastic cover from roller 2. Loosen the nut 3. Turn the 6 sides plastic cover Left or Right for release the door on Top and Bottom of door. Note: the roller is off set to loosen or tighten the door to the frame 4.
Cleaning and Maintenance 1. When it comes to daily cleaning, liquid detergent and soft cloth should be used. DO NOT sterilize it with acetone and ammonia detergents. Do not use detergent with formic acid or formaldehyde. Do not use any abrasive cleaners. 2.
Main Control Panel 1. LCD 2. Massage Jets Function 3. Rainfall Shower Head Function 4. Telephone Function 5. Fan Function 6. Radio / CD Function 7. Top Light Function 8. ON/OFF 9. Steam Function 10. Function Key 11. – Key 12.
Introduction to Functions 1. ON/OFF 2. Light Lamp Function 3. Circulation Fan Function 4. Steam Function 5. Steam Time Function 6. Steam Temperature Function 7. Radio Function Description of Functions 1. ON/OFF Key Under ON state, press key on the panel or remote control key to start the system, the top light will come on, and functions will be activated and illuminated on the LCD display.
Page 20
Caution: Setting aroma jar must screw the nut when the testing line from control box and connect to the water level probe of Aroma jar. If the nut is too loose, between the inside of the probe and the jar wall, the probe will not work during testing.
Technical Data Work Condition and Features Rated Voltage AC220V Rated Frequency 50 - 60 Hz Rated Current 6.9A Rated Power 1520W Insulation > 20M Ω Waterproof Grade IPX4 Resistance Loading Configuration Data Load Rated Load Voltage Rated Load Frequency Rated Load Power Others Steam AC220V...
Need help?
Do you have a question about the M-A021 and is the answer not in the manual?
Questions and answers