Electrolux EWN 14580 W User Manual page 35

3. Set the hose correctly by loosening
the ring nut.
After positioning the inlet hose, be
sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a
3/4" thread. Always use the hose
supplied with the appliance. The
inlet hose must not be lengthened. If
it is too short and you do not wish
to move the tap, you will have to
purchase a new, longer hose
specially designed for this type of
use.
Note !
Installation should comply with
local water authority and building
regulations' requirements.
The appliance must be connected to a
cold water supply. A minimum water
pressure of 0.05 MPa (0.5 bar) is
required for safe operation of the
appliance.
If you cannot make the cold water
connection direct from the rising mains,
you may be able to operate the
appliance from your cold water storage
system.
There should be a minimum vertical
distance of 5.02m (16.5 ft) between
the appliance's inlet and the bottom of
the water storage tank.
Water drainage
This appliance is designed to be
permanently plumbed into your home's
drainage system using one of the
following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the
drain hose using the «U» piece
supplied.
e e
ed
Place the drain hose into your
standpipe, which should have an
internal diameter of approximately
38mm thus ensuring there is an air
break between the drain hose and
standpipe.
installation electrolux 35