Table of Contents
Advertisement
2. Hardware Installation
This chapter explains how to install DTR-100DB hardware with your PC or Notebook.
Please follow the procedures as described below
2.1 Connecting USB Port
Connect USB connector of the DTR-100DB Receiver to the USB port of your computer or
notebook.
2.2 Connecting Terrestrial Antenna
Connect supplied ISDB-T antenna to the VHF/UHF port on the backside of the DTR-100DB.
Note:
(1) If you install the DTR-100DB with Notebook, please make sure the "Power Saving"
function is turned OFF. (The "Power Saving" function will lower down the CPU
performance and may effect the DTR-100DB's operation).
(2) Be sure to connect the antenna to the DTR-100DB and adjust it to a better reception angle
and location every time you play with the Receiver.
8
Advertisement
Table of Contents
Need help?
Do you have a question about the DTR-100DB and is the answer not in the manual?