Table of Contents
Advertisement
You must select this option after you have
set the programme and before you press
button 6.
You can cancel or modify the delay time at
any moment, before you press button 6.
Selecting the delayed start:
1. Set the programme and the required
options.
2. Press button 7 to set the delay start .
3. Press button 6:
– the machine starts its hourly count-
down.
– The programme will start after the
selected delay has expired.
Cancelling the delayed start after having
pressed button 6:
1. Press button 6 to set the washing ma-
chine to PAUSE.
2. Press button 7 once until the value
is displayed
3. Press button 6 again to start the pro-
gramme.
Important! The selected delay can be
changed only after selecting the washing
programme again.
The Delay Start can not be selected with
the DRAIN programme.
START THE PROGRAMME BY
PRESSING BUTTON 6
To start the selected programme, press the
button 6, the corresponding green pilot light
stops blinking. The pilot lights 8.1 and 8.2
illuminate to indicate that the appliance
starts operating and the door is locked.
To interrupt a programme which is running,
press the button 6: the corresponding
green pilot light starts blinking.
To restart the programme from the point at
which it was interrupted, press the button 6
again. If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the red pi-
lot light of the button 6 blinks for 3 times
the message Err is displayed for a few sec-
onds.
ALTERING AN OPTION OR A RUNNING
PROGRAMME
It is possible to change some options be-
fore the programme carries them out.
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 6.
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
gramme position. Start the new programme
by pressing the button 6 again. The wash-
ing water in the tub will be not emptied out.
INTERRUPTING A PROGRAMME
Press the button 6 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
CANCELLING A PROGRAMME
'
Turn the selector dial to
gramme which is running.
You can select now a new programme.
OPENING THE DOOR
After the programme has started (or during
the delay time) the door is locked. If you
need to open the door, press first the but-
ton 6 to set the machine to PAUSE. After a
few minutes the light 8.2 goes out. It is pos-
sible to open the door.
If this light remains lit and the door is
locked, this means that the machine is al-
ready heating or that the water level is too
high. In any case, do not try to force the
door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to
few minutes the door can be opened (pay
attention to the water level and temper-
ature!).
After closing the door, it is necessary to set
the programme and options again. Press
button 6 to start the machine.
AT THE END OF THE PROGRAMME
The machine stops automatically. The dis-
play shows three blinking zeros (
Some acoustic signals sound. The light of
button 6, the lights 8.1 and 8.2 go off.
After some minutes the light 8.3 illuminates.
The door can be opened.
electrolux 11
and then to the new pro-
to cancel a pro-
. After a
).
Advertisement
Table of Contents
