Table of Contents
Advertisement
Special programmes
limp. pelusas / fios (Fluff Clean)
This programme is executed to clean the drying circuit of any fluff
deposits. The time at which the programme needs to be run is determined
automatically by the
is determined automatically by the washer-dryer and indicated by the
limp. pelusas / fios (Fluff Clean) symbol remains lit until the programme
has been successfully completed.
To run the limp. pelusas / fios (Fluff Clean) programme, proceed as
follows:
Make sure that the drum is completely empty and close the door.
Set the programme selector to limp. pelusas / fios (Fluff Clean).
Press the A (Inicio/Pausa) button.
At the end of the programme, the limp. pelusas / fios (Fluff Clean)
symbol goes out.
You can also run the limp. pelusas / fios (Fluff Clean) programme at any
i
time without prompting from the appliance.
'+B (Rinse + Spin)
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the
programme → page 13.
t
+ B (Empty + Spin)
Drain the rinsing water following a programme with $ (Rinse stop)
→ page 13.
Turn the programme selector to
Set the spin speed to $ (Rinse stop).
Press the A (Inicio/Pausa) button.
or
Drain and spin at the desired spin speed:
Turn the programme selector to
Press the B (Spin) button repeatedly until the desired spin speed is
set.
Press the A (Inicio/Pausa) button.
l
(Fluff Clean) symbol on the display panel. The n
:
:
t
+B
t
+B
(Empty + Spin).
(Empty + Spin).
l
12
Advertisement
Table of Contents
