Table of Contents
Advertisement
6 electrolux
Start/Pause
This button allows you to start or to interrupt
the selected programme.
Time Manager
These buttons allows you to modify the pro-
gramme duration automatically proposed by
the appliance.
Door locked pilot light
The pilot light 9 illuminates when the pro-
gramme starts and indicates if the door can
be opened:
Display
The display shows the following information:
7.1:
• Duration of the selected programme
After selecting a programme, the duration
is displayed in hours and minutes (for ex-
ample 2.05 ). The duration is calculated
automatically on the basis of the maximum
recommended load for each type of fabric.
After the programme has started, the time
remaining is updated every minute.
• Delayed start
The Selected delay set by pressing the rel-
evant button appears on the display for a
few seconds, then the duration of the se-
lected programme is displayed again.
• Alarm codes
In the event of operating problems, some
alarm codes can be displayed, for example
E20 (see paragraph «What to do if...»).
• Incorrect option selection
If an option which is not compatible with
the set wash programme is selected, the
message Err is displayed at the bottom of
• light on: the door cannot be opened. The
• light off: the door can be opened. The pro-
• light flashing: the door is opening.
7.4
7.5
7.3
7.2
• End of programme
7.2: Washing programme phase icons
• Wash
• Rinses
• Drain
• Spin
By selecting the wash programme, the pro-
gramme phase icons corresponding to the
various phases making up the programme
are shown in the bottom part of the display.
After having pressed button 8 only the icon
of the running phase stays on.
7.3: Heating phase
During the washing cycle the display shows
a temperature icon indicating that the appli-
ance has started the heating phase of the
water in the tub.
machine in working or has stopped with
water left in the tub.
gramme is finished or the water has been
emptied out.
7.1
the display for a few seconds and the in-
tegrated red light of button 8 start flashing.
When the programme has finished three
flashing zeros are displayed, the pilot light
9 and the pilot light of button 8 go out and
the door can be opened.
Advertisement
Table of Contents
