Telefunken TX 101 User Manual page 80

- Move the handset closer to the telephone base. It might be out of range.
- Disconnect the telephone base from the telephone wall socket and connect a different
telephone. If there is no dial tone on this telephone either, the problem is in your wiring or local
service. Contact your local telephone company.
Cannot dial out or receive calls
- Check that the mains power is correctly connected.
- The battery may need recharging.
- Has there been a power cut? If so, place the handset back on the base for 10 seconds and try
again. If it still does not work disconnect the battery pack and mains power for 10 minutes, then
reconnect and try again.
You have a dial tone, but the phone will not dial out
- If you are connected to a PABX, check whether you need to dial an access code.
Handset does not ring
- The ringer volume may be switched off..
- Check that the mains power is correctly connected.
- Make sure the handset is registered to the base.
No display
- The battery pack may be flat, dead or incorrectly inserted.
- Recharge or replace the battery pack
Battery icon does not appear to be filling
- Try cleaning the charging contacts.
- Check that the mains power is correctly connected.
- If the above measures do not correct the problem, replace the battery pack.
You hear the busy tone when you press HOME
- Make sure the handset is in range of the base.
- Another handset registered to your TELEFUNKEN TX 1** base may be on the line.
Answering machine does not record any messages
- Make sure the answering machine is switched on.
- The memory may be full, please delete some old messages to free up space.
- Make sure answering machine is set to ANSWER & RECORD mode.
Answering machine messages have the wrong date and time
- Have you manually set the date and time?
Cannot access your messages from another phone
- Have you changed the remote access security PIN code?. Always keep a note of the new PIN
code in a safe place.
- Has remote access been disabled?
- Make sure you are calling from a touch-tone telephone. When dialing a number, there should be
tones. If there are clicks, then it is not a touch-tone telephone and cannot activate the answering
machine.
- The answering machine might not detect the remote access code when your announcement is
playing. Wait until the announcement is over before entering the code.
- There might be interference on the telephone line you are using. Press the dial pad keys firmly
when dialing.
No Caller number/name displayed
- Have you subscribed to Caller ID service?
- The caller may have blocked their number.
TX Bluetooth 80