Leak Test And Function Test; If Gas Escapes; Checking The Gas Connection - Bosch Hob Installation Instructions Manual

Leak test and function test

If gas escapes

Checking the gas
connection
24
24.Replace the pan supports or racks. Make sure that
the pan support is placed in the correct position on
the hob.
25.Carefully refit the control knobs.
26.At this stage, make sure that you check the flame
characteristics. See the section "Safe flame
characteristics".
27.Check that the appliance functions without any
faults.
d
Make sure that no sparks are generated. Do not
use fire or naked flames.
There is a risk of explosion.
Check the tightness with suitable foam.
Close the locking device.
Ventilate the room sufficiently.
Check the gas and nozzle connections once more.
Repeat the leak test.
The leak test should be carried out by two persons as
follows.
1. Open the locking device for the gas connection.
2. Moisten the area around the gas connection with
foam.
If the foam dissolves or gas escapes, see "If gas
escapes".
Also check the side closed with a blind plug for leaks.