Table of Contents
Advertisement
Changing the light bulb - Fig. 5
• Disconnect the cooker hood from the main
supply.
• Press (1) the lamp cover (2) and open it.
• Replace the old bulb with a new one of the
same type (3).
• Close the lamp cover.
Special Accessories
Charcoal Filter Type 20
External motor (for external installation) 942 122 035
External motor (for internal installation) 942 122 036
What to do if
If your appliance fails to work properly please carry out the following checks.
Symptom
The cooker hood will not start...
The cooker hood is not working
The cooker hood has
switched off during operation...
If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and
serial number.
Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.
In-guarantee customers should ensure that the above checks have been made as the engineer will make a
charge if the fault is not a mechanical or electrical breakdown.
Solution
Check that: The hood is connected to the electricity supply.
Check that a fan speed has been selected
Check that: The fan speed is set high enough for the task.
The grease filters are clean.
The kitchen is adequately vented to allow the entry of fresh air.
If set up for recirculation, check that the charcoal filter is still effective.
If set up for extraction, check that the ducting and outlets are not
blocked.
The safety cut-out device has been tripped.
Turn off the hob and then wait for the device to reset.
If the hood has been installed below the heights indicated in the
installation instructions the motor will cut-out frequently which will
damage the hood.
57
Fig. 5
Advertisement
Table of Contents
