Electrolux EFC 9436 User Manual page 11

Mounting the flue support
bracket (3 sections)
Fix the three sections with 4 screws, adjust the
width of the support on the basis of the internal
width of the flue. Fig. 7
Mounting the hood on the wall –Fig. 8
Disconnect the hood from the power supply using the main switch of the house.
Remove the 2 screws inside the hood, below at the fixing points of the suction unit (also see operation 3-
removing the anti-fats filter/s or active carbon filter/s frame).
• Position the suction unit on a support and insert the lower part of the hood (1).
• Connect the two components electrically (2).
• Fix the hood to the suction unit using 8 screws (3).
• To facilitate the montage, draw a line corresponding to the centre of the apparatus (4), position the template
so that its centre corresponds to this line and the lower corner of the template corresponds to the lower
corner of the hood (5).
• Make two Ø 8 mm holes with a drill and fix the support to the wall with two dowels and two screws (6).
• Hang the hood up (7), adjust the position (8-9) and mark the hole from inside the hood for the definitive fixing
(10), remove the hood (11), make a Ø 8 mm hole with a drill (12), insert a wall dowel (13).
• Make two Ø 8 mm holes in the upper part, near the ceiling (14), insert two wall dowels and fix the support of
the flue with two screws (15).
• Hang the hood up again (16).
• Fix definitively with a screw (17).
• If the hood has to be used in a filtering version, mount a baffle F on the support of the flue (G) with four
2.9x6.5 screws and install a fumes discharge tube (18) to connect the exit of hood A with baffle F. If the
hood has to be used in a suction version, baffle F does not have to be installed and a fumes discharge tube
(18) has to be installed to connect hood exit A with the outside.
Attention! Only models EFCR 943-941: the discharge tube is to be connected to an external suction unit
(see successive paragraph "Connection to an external motor").
• Connect electrically (19) but do not connect the hood to the main panel of the house.
Attention! Only models EFCR 943-941: It is also necessary to connect electrically to an external suction
motor (see successive paragraph "Connection to an external motor".
• Fix the flue (20a) to the support (20b).
Let the lower section of the flue slide downward and insert it in the apposite housing on the upper part of the
hood.
Mount the frame of the active carbon filter and the anti-fats filter again, connect the hood to the power supply
and check that the hood is functioning correctly.
Fig. 7
61