Setting Up The Kitchen Radio; Commissioning - E-Bench KH 2289 Operating Instructions Manual

4.
Mark the four points for the drillholes with a
pencil.
5.
Mark the drillhole with a mandril.
6.
Firmly secure the mounting plate
supplied screws.
7.
Place the kitchen radio diagonally with the two
recesses in the retainer lugs of the mounting
q
plate . Press the kitchen radio up until you
hear it engage.
Secure the wire antenna with a piece of adhesive
tape such that it does not hang down.

Setting up the kitchen radio

Do not set up the kitchen radio without the mounting
q
plate . Otherwise the speakers are covered and
the sound is scarcely audible.
To set up the kitchen radio with the enclosed moun-
ting plate q :
1.
Simultaneously press the two retaining levers
on the back of the appliance down. Push the
mounting plate q
2.
Push the two retainer lugs on the mounting pla-
q
te into the recesses on the lower rear side of
the kitchen radio.
3.
Firmly press the front part of the mounting plate
q
down until you hear it engage. You can now
set up the radio.
To disassemble the mounting plate
q
mounting plate from below with the thumbs and
press it forwards and up until it disengages. You can
now remove the mounting plate
q
with the
back and remove it.
q
, grip the
q
.

Commissioning

Inserting the back-up batteries
The back-up batteries ensure that the programmed
time, date, alarm time and set SDAs (Special Day
Alert) are not erased in the event of a power failure.
For this, you require two 1.5V batteries of type
AAA. They are not supplied with the appliance.
1.
Open the lid of the battery compartment
the underside of the kitchen radio.
2.
Insert the batteries. Make sure the polarities
are correct.
3.
Close the lid of the battery compartment
The lid must audibly engage.
Take note:
The back-up batteries must be checked at least
once per year and, if necessary, exchanged
for new ones.
Providing mains power
• Insert the plug into a power socket. The kitchen
radio starts in automatic mode. Appearing re-
peatedly in the display is
„PLEASE WAIT FOR SETTING THANKS".
When an RDS-Signal is received, the date and time
are automatically adjusted. The current time is
shown in the display.
If the time is not correctly displayed, enter in the
correct date and time manually as described in
the following sections.
- 5 -
g
on
g
.