Something Not Working - Electrolux EWF1045 Instruction Booklet

Something not working?

Problems which you can resolve yourself.
During the machine operation it is possible that one of the following alarm codes appears:
- : there is no water fill
E E 1 1 0 0
- : the water is not drained
E E 2 2 0 0
- : door open
E E 4 4 0 0
Once the problem has been eliminated, press the "Inicio/Pausa" button to restart the programme. If after all
checks, the problem persists, contact your local Service Force.
Problem
• The machine does not start up:
• The machine does not fill:
• The machine fills then empties
immediately:
• The machine does not empty and/or
does not spin:
• There is water on the floor:
• Unsatisfactory washing results:
• The machine vibrates or is noisy:
Possible cause
• The door is not firmly closed. (
• The machine is not plugged in or there is no power
at the socket.
• The main fuse has blown.
• The programme selector dial is not positioned
correctly.
• The "Inicio/Pausa" button has not been depressed.
• The "Inicio Diferido" button has not been
depressed.
• The water tap is closed. (
• The inlet hose is squashed or kinked. (
• The filter in the inlet hose is blocked. (
• The door is not properly closed. (
• The end of the drain hose is too low. Refer to
relevant paragraph in "water drainage" section.
• The drain hose is squashed or kinked. (
• The option has been selected. (
• The drain filter is clogged.
• Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
• The drain hose is damaged.
• The cap on the emergency emptying hose has not
been replaced after cleaning the pump.
• The cap on the emergency emptying hose has not
been fully screwed in after cleaning.
• Too little detergent or unsuitable detergent has
been used.
• Stubborn stains have not been treated prior to
washing.
• The correct programme/temperature was not
selected.
• Excessive laundry load.
• The transit bolts and packing have not been
removed.
• The support feet have not been adjusted.
• The laundry is not evenly distributed in the drum.
• Maybe there is very little laundry in the drum.
50
)
E E 4 4 0 0
)
E E 1 1 0 0
)
E E 1 1 0 0
)
E E 1 1 0 0
)
E E 4 4 0 0
)
E E 2 2 0 0
)
E E 2 2 0 0