Table of Contents
Advertisement
When placing the appliance ensure that it stands level.
This can be achieved by two adjustable feet (1) at the
bottom in front. 1-1 piece of distance washers (2) are
accessories of the adjustable feet. If levelling the appli-
ance requires, these washers can be removed.
Do not stand the appliance on a sunny place or close to
a radiator or cooker.
If it is unavoidable because of furnishing and the appli-
ance has to be stood near a cooker take these mini-
mum distances into consideration:
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5 - 1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must be
30 cm since they give off more heat.
The refrigerator is designed to operate when it is totally
pushed to the wall.
When placing the refrigerator keep minimal dis-
tances recommended in figure.
A : placing it under a wall-cupboard
B : placing it freely
Switch and indicator unit
For the usage of the switching and indicator unit see
chapters "Putting it into use", "Controlling the tempera-
ture" and "Freezing".
Components of the appliance are as follows:
A)Green indicator lamp
This lamp lights when the appliance is under power,
i.e. the mains plug is in the mains socket.
B)Red indicator lamp
It lights up depending on the temperature inside the
appliance.
It lights for a short time when starting the appliance,
placing fresh food into it and when the temperature
control knob has been turned in direction to lower
temperatures.
It lights permanently when the temperature inside the
appliance is too high (overloaded with warm food,
door stayed open or the door seal does not close
properly) or possibly the appliance was broken down.
C)Yellow indicator lamp and freezer switch
In the switched-on state of the switch (pops up and
lights by pressing) the compressor operates continu-
ously thus providing for the coldest interior tempera-
ture - achievable by the freezer - needed for freezing.
D)Temperature control knob
This knob is provided for setting and changing the
temperature inside the appliance.
GB
2
1
43
Advertisement
Table of Contents
