Installing The Cisco Nexus B22 Fabric Extender For Dell - Dell Nexus B22 Getting Started Manual

•
Mezzanine card type must match the fabric type of the I/O modules installed in corresponding I/O
module slots.
Dell FEX LEDs
Table 1
Module State
Module Off
Boot in Progress
Normal Boot 
(No faults)
IOM Fault 
(Self -Diagnosed)
IOM Fault 
(Misconfiguration or other CMC detected fault)
Module Identify
(Activated from CMC)

Installing the Cisco Nexus B22 Fabric Extender for Dell

Caution Properly ground yourself before handling the Fabric Extender.
Populate all the chassis interconnect bays with a connection blade or one of the blank panels provided
with the chassis.
To install the Cisco Nexus B22 Fabric Extender for Dell in the chassis:
1.
2.
Mezz Port 2 to I/O Module C2, port n+8
Blade d Mezzanine card supports Fabric B
Mezz Port 1 to I/O Module B1, port n+8
Mezz Port 2 to I/O Module B2, port n+8
shows the descrition of the Dell FEX LEDs:
Table 1
Locate the appropriate interconnect bay at the rear of the chassis. See the setup and installation guide
provided with the chassis.
Press the handle latch to release the handle.
Installing the Cisco Nexus B22 Fabric Extender for Dell
IOM Dell Defined LED behavior Chart
Power LED (Green)
OFF
ON
ON
ON
OFF
ON
Cisco Nexus B22 Fabric Extender for Dell Getting Started Guide
Health LED
(Blue/Amber)
OFF
OFF
ON
Blue
Blink (1Hz)
Amber
Blink (1Hz)
Amber
Blink (1Hz)
Blue
7